RT-N66U login: admin Password: ASUSWRT RT-N66U_3.0.0.3 Thu Aug 9 14:02:36 UTC 2012 admin@RT-N66U:/tmp/home/root# dmesg Linux version 2.6.22.19 (root@asus) (gcc version 4.2.4) #1 Thu Aug 9 22:16:15 CS T 2012 CPU revision is: 00019749 Determined physical RAM map: memory: 07fff000 @ 00000000 (usable) memory: 08000000 @ 87fff000 (usable) Entering add_active_range(0, 0, 32767) 0 entries of 256 used Entering add_active_range(0, 557055, 589823) 1 entries of 256 used Zone PFN ranges: Normal 0 -> 131072 HighMem 131072 -> 589823 early_node_map[2] active PFN ranges 0: 0 -> 32767 0: 557055 -> 589823 On node 0 totalpages: 65535 Normal zone: 0 pages used for memmap Normal zone: 0 pages reserved Normal zone: 32767 pages, LIFO batch:7 HighMem zone: 0 pages used for memmap HighMem zone: 32768 pages, LIFO batch:7 Built 1 zonelists. Total pages: 65535 Kernel command line: root=/dev/mtdblock2 noinitrd console=ttyS0,115200 Primary instruction cache 32kB, physically tagged, 4-way, linesize 32 bytes. Primary data cache 32kB, 4-way, linesize 32 bytes. Synthesized TLB refill handler (20 instructions). Synthesized TLB load handler fastpath (32 instructions). Synthesized TLB store handler fastpath (32 instructions). Synthesized TLB modify handler fastpath (31 instructions). PID hash table entries: 512 (order: 9, 2048 bytes) CPU: BCM5300 rev 1 pkg 0 at 600 MHz Using 300.000 MHz high precision timer. console [ttyS0] enabled Dentry cache hash table entries: 16384 (order: 4, 65536 bytes) Inode-cache hash table entries: 8192 (order: 3, 32768 bytes) Memory: 255088k/131068k available (2445k kernel code, 6756k reserved, 495k data, 168k init, 131072k highmem) Calibrating delay loop... 299.82 BogoMIPS (lpj=1499136) Mount-cache hash table entries: 512 NET: Registered protocol family 16 PCI: Initializing host PCI: Reset RC PCI: Initializing host PCI: Reset RC PCI: Fixing up bus 0 PCI/PCIe coreunit 0 is set to bus 1. PCI: Fixing up bridge PCI: Setting latency timer of device 0000:01:00.0 to 64 PCI: Fixing up bridge PCI: Setting latency timer of device 0000:01:00.1 to 64 PCI: Enabling device 0000:01:00.1 (0004 -> 0006) PCI: Fixing up bus 1 PCI/PCIe coreunit 1 is set to bus 2. PCI: Fixing up bridge PCI: Setting latency timer of device 0000:02:00.0 to 64 PCI: Fixing up bridge PCI: Setting latency timer of device 0000:02:00.1 to 64 PCI: Enabling device 0000:02:00.1 (0004 -> 0006) PCI: Fixing up bus 2 NET: Registered protocol family 2 Time: MIPS clocksource has been installed. IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 4096 (order: 3, 32768 bytes) TCP bind hash table entries: 4096 (order: 2, 16384 bytes) TCP: Hash tables configured (established 4096 bind 4096) TCP reno registered highmem bounce pool size: 64 pages squashfs: version 3.2-r2 (2007/01/15) Phillip Lougher io scheduler noop registered (default) HDLC line discipline: version $Revision: 4.8 $, maxframe=4096 N_HDLC line discipline registered. Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing disabled serial8250: ttyS0 at MMIO 0xb8000300 (irq = 8) is a 16550A serial8250: ttyS1 at MMIO 0xb8000400 (irq = 8) is a 16550A PPP generic driver version 2.4.2 MPPE/MPPC encryption/compression module registered NET: Registered protocol family 24 PPPoL2TP kernel driver, V0.18.3 PPTP driver version 0.8.5 Physically mapped flash: Found 1 x16 devices at 0x0 in 16-bit bank Amd/Fujitsu Extended Query Table at 0x0040 Physically mapped flash: CFI does not contain boot bank location. Assuming top. number of CFI chips: 1 cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness. Flash device: 0x2000000 at 0x1c000000 Creating 5 MTD partitions on "Physically mapped flash": 0x00000000-0x00040000 : "pmon" 0x00040000-0x01fe0000 : "linux" 0x00168b30-0x01340000 : "rootfs" 0x01fe0000-0x02000000 : "nvram" 0x01f40000-0x01fe0000 : "jffs2" Found an serial flash with 0 0KB blocks; total size 0MB sflash: found no supported devices dev_nvram_init: _nvram_init _nvram_init: allocat header: 2280980480, size= 32768 sdhci: Secure Digital Host Controller Interface driver sdhci: Copyright(c) Pierre Ossman u32 classifier OLD policer on Netfilter messages via NETLINK v0.30. nf_conntrack version 0.5.0 (2048 buckets, 16384 max) ipt_time loading ip_tables: (C) 2000-2006 Netfilter Core Team net/ipv4/netfilter/tomato_ct.c [Aug 9 2012 22:15:38] NET: Registered protocol family 1 NET: Registered protocol family 10 ip6_tables: (C) 2000-2006 Netfilter Core Team NET: Registered protocol family 17 802.1Q VLAN Support v1.8 Ben Greear All bugs added by David S. Miller VFS: Mounted root (squashfs filesystem) readonly. Freeing unused kernel memory: 168k freed Warning: unable to open an initial console. ctf: module license 'Proprietary' taints kernel. et_module_init: passivemode set to 0x0 PCI: Setting latency timer of device 0000:00:01.0 to 64 eth0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 5.100.138.20 wl_module_init: passivemode set to 0x0 PCI: Enabling device 0000:01:01.0 (0000 -> 0002) PCI: Setting latency timer of device 0000:01:01.0 to 64 eth1: Broadcom BCM4331 802.11 Wireless Controller 5.100.138.20 PCI: Enabling device 0000:02:01.0 (0000 -> 0002) PCI: Setting latency timer of device 0000:02:01.0 to 64 eth2: Broadcom BCM4331 802.11 Wireless Controller 5.100.138.20 Algorithmics/MIPS FPU Emulator v1.5 usbcore: registered new interface driver usbfs usbcore: registered new interface driver hub usbcore: registered new device driver usb SCSI subsystem initialized Initializing USB Mass Storage driver... usbcore: registered new interface driver usb-storage USB Mass Storage support registered. ufsd: driver 8.5 (U85_S[2011-11-01-13:41:37]) LBD=ON with ioctl loaded at c02150 00 NTFS support included Built_for__asus_n66u_2011-10-27 ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver PCI: Setting latency timer of device 0000:00:04.1 to 64 ehci_hcd 0000:00:04.1: EHCI Host Controller ehci_hcd 0000:00:04.1: new USB bus registered, assigned bus number 1 ehci_hcd 0000:00:04.1: EHCI Fastpath: New EHCI driver starting ehci_hcd 0000:00:04.1: irq 6, io mem 0x18004000 ehci_hcd 0000:00:04.1: USB 0.0 started, EHCI 1.00 usb usb1: configuration #1 chosen from 1 choice hub 1-0:1.0: USB hub found hub 1-0:1.0: 2 ports detected ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver PCI: Setting latency timer of device 0000:00:04.0 to 64 ohci_hcd 0000:00:04.0: OHCI Host Controller ohci_hcd 0000:00:04.0: new USB bus registered, assigned bus number 2 ohci_hcd 0000:00:04.0: irq 6, io mem 0x18009000 usb usb2: configuration #1 chosen from 1 choice hub 2-0:1.0: USB hub found hub 2-0:1.0: 2 ports detected usbcore: registered new interface driver usblp drivers/usb/class/usblp.c: v0.13: USB Printer Device Class driver usb 1-1: new high speed USB device using ehci_hcd and address 2 usb 1-1: configuration #1 chosen from 1 choice hub 1-1:1.0: USB hub found hub 1-1:1.0: 4 ports detected usbcore: registered new interface driver asix usbcore: registered new interface driver cdc_ether usbcore: registered new interface driver net1080 usbcore: registered new interface driver rndis_host usbcore: registered new interface driver zaurus register_vlan_device: ALREADY had VLAN registered usb 1-1.4: new high speed USB device using ehci_hcd and address 3 register_vlan_device: ALREADY had VLAN registered usb 1-1.4: configuration #1 chosen from 1 choice scsi0 : SCSI emulation for USB Mass Storage devices br0: starting userspace STP failed, staring kernel STP vlan1: add 33:33:00:00:00:01 mcast address to master interface vlan1: add 01:00:5e:00:00:01 mcast address to master interface vlan1: dev_set_promiscuity(master, 1) device eth0 entered promiscuous mode device vlan1 entered promiscuous mode scsi 0:0:0:0: Direct-Access Multi Flash Reader 1.00 PQ: 0 ANSI: 0 sd 0:0:0:0: [sda] Attached SCSI removable disk sd 0:0:0:0: Attached scsi generic sg0 type 0 COEX: downgraded chanspec 0x2e04 to 0x2b06: channel 1 used by exiting BSSs device eth1 entered promiscuous mode device eth2 entered promiscuous mode br0: port 3(eth2) entering listening state br0: port 2(eth1) entering listening state br0: port 1(vlan1) entering listening state br0: port 3(eth2) entering learning state br0: port 2(eth1) entering learning state br0: port 1(vlan1) entering learning state br0: topology change detected, propagating br0: port 3(eth2) entering forwarding state br0: topology change detected, propagating br0: port 2(eth1) entering forwarding state br0: topology change detected, propagating br0: port 1(vlan1) entering forwarding state nf_conntrack_rtsp v0.6.21 loading nf_nat_rtsp v0.6.21 loading autodet uses obsolete (PF_INET,SOCK_PACKET) gro enabled with interval 2 Ebtables v2.0 registered device eth1 left promiscuous mode br0: port 2(eth1) entering disabled state device eth2 left promiscuous mode br0: port 3(eth2) entering disabled state COEX: downgraded chanspec 0x2e04 to 0x2b06: channel 1 used by exiting BSSs device eth1 entered promiscuous mode br0: port 2(eth1) entering listening state br0: port 2(eth1) entering learning state br0: topology change detected, propagating br0: port 2(eth1) entering forwarding state device eth2 entered promiscuous mode br0: port 3(eth2) entering listening state br0: port 3(eth2) entering learning state br0: topology change detected, propagating br0: port 3(eth2) entering forwarding state COEX: downgraded chanspec 0x2e04 to 0x2b06: channel 1 used by exiting BSSs COEX: downgraded chanspec 0x2e04 to 0x2b06: channel 1 used by exiting BSSs COEX: downgraded chanspec 0x2d03 to 0x2b01: channel 2 used by exiting BSSs