alexcavazos67
New Around Here
Hi,
I need help on how to configure my router so it will work with my proxy DNS and load balancing.
I have a Linksys LRT224 router. I have two broadband connections from two separate ISPs,500Mbps each (WAN1 & WAN2). WAN1 has a static IP and WAN2 is dynamic assigned. I use Unlocator (www.unlocator.com) so I can access geographically restricted sites (Pandora, Netflix, etc.).
The problem I have is that unlocator registers only one IP address (WAN1 address) and since I am doing load balancing I have no way of knowing if the DNS request will go through the registered IP (WAN1) or through the other (WAN2). I am not an expert in routing or networking but I'm guessing I have a way of configuring the router so all the DNS requests go out through WAN1, right?
In the router's Dual WAN config page there is a section for Protocol Binding. I tried to configure but only managed to screw up the internet at home.
Any help or suggestions are appreciated.
Alex
I need help on how to configure my router so it will work with my proxy DNS and load balancing.
I have a Linksys LRT224 router. I have two broadband connections from two separate ISPs,500Mbps each (WAN1 & WAN2). WAN1 has a static IP and WAN2 is dynamic assigned. I use Unlocator (www.unlocator.com) so I can access geographically restricted sites (Pandora, Netflix, etc.).
The problem I have is that unlocator registers only one IP address (WAN1 address) and since I am doing load balancing I have no way of knowing if the DNS request will go through the registered IP (WAN1) or through the other (WAN2). I am not an expert in routing or networking but I'm guessing I have a way of configuring the router so all the DNS requests go out through WAN1, right?
In the router's Dual WAN config page there is a section for Protocol Binding. I tried to configure but only managed to screw up the internet at home.
Any help or suggestions are appreciated.
Alex