Menu
What's new
By:
Filters Better Search

Search results

  • SNBForums Code of Conduct

    SNBForums is a community for everyone, no matter what their level of experience.

    Please be tolerant and patient of others, especially newcomers. We are all here to share and learn!

    The rules are simple: Be patient, be nice, be helpful or be gone!

  1. S

    Scribe Strange Issue with Scribe / Syslog-NG after Reboot

    About 3 months ago, I rebooted my AX86U and noticed afterwards that syslog-ng was not logging correctly. The files were simply not being updated. Scribe status showed everything as working. Rather than investigate, I just did a scribe restart and the logging began working fine again. The...
  2. S

    Scribe DHCP Message Log

    I have Scribe installed with a variety of filters, working great. I would like to have a separate log of DHCP messages available in the Scribe web-ui page, without affecting the dnsmaq.log file itself. I run diversion, which sets dnsmasq to log directly to /opt/var/log/dnsmasq.log. Can I...
  3. S

    Wireless Log Alternative on AIMesh Node?

    For years, I have used an Asus Router and a second Asus Router (in AP mode) as an access point (wired via Cat6). Current hardware is RT-AX86U and RT-AC86U, both running recent RMerlin firmware. I decided to try out AiMesh, so I reset the AP and set it up as an AiMesh Node with wired backhaul...
  4. S

    AC86U - httpd not responding

    I have an AC86U with Merlin 386.3_2. It was setup "from scratch" after installing 386.3_2 and a full reset to defaults, a few months ago. Only additions are Diversion and SkyNet. There are about 40 active devices. NVRAM usage is 70168/131072. There is a 2gb swap file which was created by...
  5. S

    Suppress "Custom Script Running" messages?

    I'm using Merlin 380.57 on an N66U. I recently implemented a custom dhcpc-event script to log "bound" events. That works great. But every time the script is called, the firmware posts an informational message to the system log, like this one: Mar 4 12:39:02 custom script: Running...
  6. S

    IPV6 Activation

    I am having a problem activating IPv6. The router is a N66U with RMerlin 3.0.0.4.374.33 firmware. (I had the same problem when using RMerlin 3.0.0.4.374.32. When I upgraded to the .33 release, I reset to factory defaults and setup from scratch.) Everything works perfectly when running in...
  7. S

    Client List in AP mode?

    I have two N66U's running RMerlin 270.26b. One is in "router mode", acting as the home's router and primary wireless access point. The second is in "AP mode", and simply provides extended wireless client coverage at the other end of the house. Wired topology looks like this...
Top