Recent content by 0ID

Ah, its you again! Now I understand why you have over 17000 posts here. You have your say to any post.

My message was meant to @fknz to be aware o different user recommendations from different parts of the world. But you'll right amazon.pl is in Poland!

! the wifi devices made for European market have different power outputs and different channels as those made for NA market !

Isn't cheaper to wire the existing points with temporary wires, purchase a 3 unit mesh pack and test the coverage and speed. If happy, keep the set and permanently install, if possible, the needed ethernet wires.

Same here, the hidden networks are on WPA2 and @Tech9 : No way to get a reply from Asus.

Thanks for your reply. The cabling (cat5e) should be fine, as the 2.5G switch connecting the two nodes reports a 2.5G speed, as does the GUI, and another connection to a 1G switch reports as 1G. What's wrong with wanting a higher backhaul speed? I was just hoping for a simpler solution as...

Elon has a cleverer AI. This would probably recommend to double the dosis and read a bible purchased directly. You know the salesman, as seen on TV.

I'm thinking about how to speed up the backhaul from 1G to 2.5G to 2 Ethernet connected XT9 mesh satellites. In the manual I found an option to use LAN3 (1G) as a new WAN, then connect a 2.5G switch to the original 2.5G WAN port to which the backhauls of 2 nodes + a 1G link would go. The manual...

I have separate SSIDs for 2.4 and 5 GHz bands.

You may wonder why I'm so stubborn about these hidden backhaul streams, but at the moment I can see a total of 64 WiFi streams in my area + these 2 of mine... That's why!

Except Asus?

If you would read my entire post, you'll find out that Im talking about 1 (one) vacuum cleaner in 2.4 band and 2 devices used to control the robot from WiFi6 - 5GHZ. Please stop replying.

Thank you, but I expected an answer from somebody ho knows... and this is has nothing to do with phones. Its about the switching between mesh nodes, I already changed the roaming assistant from -70 to -60dBm but still wont switch to a node with much more powerful signal

Should I turn on wifi agile multiband in XT Ai Mesh system? It says Multiband but settings are available separately for 2.4 and for 5-1 + 5-2 (smart connect) pages in wireless general settings I would like to use this function ONLY in 2.4 GHz band for only one IoT device - a robot vacuum...

@OzarkEdge YES, definitively, the firmware needs improvement. "The normal" in case of Ethernet Backhaul Mode enabled should be wireless backhaul OFF. Asus should be more concerned about polluting the environment with unnecessary transmissions and reducing the power consumption of their devices.