What's new
By:

  • SNBForums Code of Conduct

    SNBForums is a community for everyone, no matter what their level of experience.

    Please be tolerant and patient of others, especially newcomers. We are all here to share and learn!

    The rules are simple: Be patient, be nice, be helpful or be gone!

Recent content by Ad0

  1. A

    Duplex problem

    I "Fixed" the problem by buying an Ubiquiti EdgeRoter Lite :P
  2. A

    Duplex problem

    Bump! Firmware bug or hardware limitation?
  3. A

    Duplex problem

    Thanks for helping guys. My fear is that I need to get an Edgerouter Lite https://www.ubnt.com/edgemax/edgerouter-lite and set the asus as a "stupid" AP. This is from the manual for the transciever MRV EM316F/S1: "C. LIN does not operate in an “Auto Negotiation Environment”. All attached...
  4. A

    Duplex problem

    Yes I tried this as well. Gave me an error which nobody else had :( admin@RT-AC68U:/tmp/home/root# et -i eth0 speed 100full etcspeed: Invalid argument
  5. A

    Duplex problem

    robocfg.c header says "Broadcom BCM5325E/536x switch configuration utility". Maybe it just writes the wrong stuff to the wrong registers, which makes the link go in to fail mode? I suspect so. where's mii-tool? I see the .c file in the merlin source...
  6. A

    Duplex problem

    Yes exactly. But would changing to something lie dd-wrt and tomato remedy the problem? That's the big question. I am in dire straits here because I have to move a server today and everything was supposed to be set up. :(
  7. A

    Duplex problem

    Hi! The "other end" is the fiber -> ethernet adapter, and there is no way to change it. My NIC on my PC is connected to the LAN side of the router. I am asking for the WAN side of the router connected to this fiber -> ethernet adapter. It is me who has to force it on the WAN side. :(
  8. A

    Duplex problem

    I know that the router's ability is 10/100/1000 Mbps, but I wondered about it's ability to force a certain speed :)
  9. A

    Duplex problem

    Good to hear that you got lucky with your negotiation, but as I said, I need to adhere to 100MB full duplex which the remote interface is configured as, which means that I need to know how to force it.
  10. A

    Duplex problem

    I try to use robocfg to force the WAN interface to use 100 mbit full duplex. This is a requirement from the ISP. It negotiates to 100 mbit HALF duplex... admin@RT-AC68U:/tmp/home/root# robocfg showports Switch: enabled Port 0: 100HD enabled stp: none vlan: 2 jumbo: off mac: 00:0a:41:65:84:3f...
  11. A

    Multiple WAN ips with corresponding local gateways

    I managed to do 1:1 NAT to the internal IP but that's not what I really want. I would really want a gateway, so I don't have to speficy IPs to be masqueraded.
  12. A

    Multiple WAN ips with corresponding local gateways

    I have a range of static IPs I got from my ISP. What I want to do is to do as I do with the primary IP. Set it up with a corresponding gateway like 192.168.1.1 and computers in the LAN can specify this, and use NAT to open ports etc. So in example I have the public IP from ISP which is...
See more
Back
Top
✖