Recent content by afool622

Guest network disappearing and disconnecting device Zenwifi BT10. Guest network is vlan. Any idea what would cause this? I'm just using this guest network to isolate my work machines. Error I see in the logs:

Saw a bt10 on sale and was thinking about doing the same thing. Hope it works out. I hear that iot devices have issues though.

I had similar issue. It was recommended that I do a reset and reconfigure everything. This did solve it

Thanks for everyones input. Got both back up and running (took a bit of time). Keeping them on stock for now. @tgl was right on turning off all Asus units. That was my initial problem. My other problem was that the aimesh node doesn't seem to connect after changing mode to aimesh node. So...

Thank you!! Do you have directions on flashing a node without gui access?

Help! I hard resetted both my router and my node. However, my node is no longer connecting to my router. How can I revert the node firmware? router: xt8 firmware: trying many things, I have reverted the router back to RT-AX95Q_386.07_2-gnuton1_cferom_puresqubi ai node...

@Dav3 see if the release assets work for you https://github.com/gnuton/asuswrt-merlin.ng/releases

ok tried one more time with the new beta with the node in the same room and same issue. looking at the wireless logs it shows that the node is not in the stations list at all. I will provide the beta and the 386.07_2-gnuton1 outputs if it helps. Current Version : 386.07_2-gnuton1...

Thanks GNUton!! I didn't change any wifi configs for the backhall. My node is also a floor away. I may try to put it next to each other and see if that changes anything. Any other advice on a config that might affect the backhall ? Thanks again!

Merry Christmas all! So I updated to 388.1 beta2 and I'm still getting weak wireless backhull connection between my node and router (for my xt8). What logs can help me debug this issue? I'm also not sure how to pull logs from the node, if someone can point me to how to do so. Thanks all.

For my xt8 main node the beta runs fine. My aimesh node doesn't seem to like it, it doesn't seem to connect well when using the beta. Since you are using eth back hall, I say give it a shot

I updated my xt8 (dirty, no reset) and the only problem I seem to be hitting is when I update my mesh node to the matching alpha, the wifi backhall doesn't connect via wifi 5 but wifi 2.4. I kept trying and trying, but going back to 386.07_2-gnuton1 resolved the weak connection (wifi 2.4)...

I got the same here: I am assuming not to update

build is based on merlin's 387.2

Just saw the new beta was built today, 15 hrs ago. Installing now