Recent content by AlpineMan

I have 2 ET12's, both configured as AP's. One was coming from firmware 3.0.0.4_388_24610 that I factory reset, then created a guest network. After upgrading to 3.0.0.6.102_36597, I noticed that the guest network that was defined carried over to the latest firmware. The guest network has VLAN...

Thank you for the reply. I failed to add that my ET12's are using MoCA bridge backhaul. My laptop connected to the AP via ethernet gets around 880mbps up/down using this bridge.

Recently upgraded from a pair of AX92U's to a pair of ZenWifi ET12's. At first I had them setup in AiMesh, but I didn't like the fact that the 2.4ghz radios on both ET12's were on the same channel...same with 5 and 6ghz radios. So I abandoned AiMesh and just set up the former node as an AP and...

You switched the power supplies only or the AX92U's units only?

My two AX92Us have been very stable and fast even after switching the AX92U node from AP to AiMesh. Unfortunately, I can't say the same for my AC68U's (firmware 386.41634)after switching them from AP. The problem was that the 2.4ghz ssid worked fine. But I think the 5ghz ssid is confused. It's...

Perhaps someone can answer this. I'm not using the built-in DNS/DHCP server in my AX92U. Instead I'm using Pi-hole (running in a VM in FreeNAS) for DNS, DHCP, and ad blocking. It's working great. If I enable Guest network and turn on isolation, wouldn't that mean the devices connected to my...

BTW, I just noticed now that my Adaptive QoS is enabled. I did not enable it. I'm suspecting that after switching to AiMesh, it was enabled by as well. I have now disabled it and I don't see any difference in speedtests. Or...it may have something to do with the Asus mobile app. I was...

Sounds like a good plan.

I have not enabled guest network on mine.

Hmmm... So far, for users here who've switched to 41712, yours is the only one that's still problematic. Try swapping your main AX92U with your other AX92U, ie use your other AX92U as main router. Disconnect any USB devices attached to your AX92U's for now. Factory reset both then setup your...

I have switched back all my AP's to AiMesh nodes out of curiosity. I have to say, I'm liking AiMesh 2.0 a lot better compared to 1.0. There are a bunch of essential settings now in 2.0 that were missing in 1.0 which caused me to switch to AP mode. My two AX92U's are on 386.41712 and three...

This is what my friend said: Uptime has been 2 Days, 16hrs and 7 minutes. Downloaded the syslog, did searches for "crash0 and "panic", none found. See a lot of deauth , disassociates, reauths, and reassociates as I move around the mesh nodes.

Is yours setup in AiMesh or AP?

Is yours setup in AiMesh or AP? I have a buddy setup in AiMesh, but his main router is an AX88U and 2 AX92U nodes. All have the latest Asus stock 386 firmware (41700 and 41712 respectively). It's stable.

Whenever I need to transfer DDNS to a different Asus router, I would either assign a new DDNS hostname on the old router or turn off DDNS altogether on the old router. I have never had to call Asus to transfer DDNS.