Recent content by altdel

http://www.belkin.com/us/pressreleases/8798355391548

Now, imagine buying a Chevy, re-program its computer and get a Toyota :)

This router uses the same Broadcom wireless radio chips as the Linksys E4200, i.e., BCM4718 & BCM4331. Their performance should be comparable. The stability of the firmware is another story. I'm running a beta TomatoUSB firmware on my E4200 and it is solid as a rock. The only drawback is that it...

So, from my understanding, this is your situation: You use an SMC router provided by your ISP (TWC) which would not allow customers access to its configuration page, and their techs can't add the port forwarding rules for you either. So, even though TWC does not block any port, you can't get...

No. You'll have to wait for DD-WRT or TomatoUSB support.

I'm on Comcast too, and noticed reduced upload speed after using the E4200. It turned out that "Upstream Bandwidth" in QoS was on "Auto". I changed it to "Manual" and set it to 6Mbps and I was back to the upload speed I used to get on speedtest.net. I have the Comcast Performance plan with...

very stable for me I've had the E4200 for close to 6 days now. It's been very stable, no reboot so far.

untested feature I'm guessing that IPV6 is not officially supported on this router, even though the code is in the firmware, is that the feature has not been fully tested. Time-to-market may have demanded that the feature support be delayed until full testing is done. I'm sure IPV6 will be...

Thank you for the review! It reaffirms my decision to jump the gun and bought the router before your review comes out. My Linksys WRT54GL has served me well for the past 4 years and I'm looking for the E4200 to do the same, although with a lot more devices connected (iPods, iPads, media playesr...

can't wait... This review has got to be the most anticipated router review at this time!!!

Here's my results I have the original firmware 1.0.00 (build 13) Nov 12, 2010. Since it is the same version as that on the linksys server, I didn't flash mine. This is the result from the first link: Your IPv4 address on the public internet appears to be XX.XX.XX.XX Your IPv6 address on the...

E4200 orderability turned on Just ordered my E4200 from the Cisco online store :) Will get it in a couple of days.

E4200 on Linksys support page I didn't see any formal announcement for it, but it can be found on Linksys's support page. http://homesupport.cisco.com/en-us/wireless/linksys/E4200 "The Linksys E4200 is a powerful simultaneous dual-band Wireless-N router optimized for maximum wireless...

FCC test report 4. For 5GHz: The EUT is 3 * 3 spatial MIMO (3Tx & 3Rx) without beam forming function. The antenna configurations are three transmitter antennas and three receiver antennas, as there are 3 PIFA antennas. Spatial multiplexing modes for simultaneous transmission using 3...

According to Wifi Alliance's certification report, it is a 3T3R for 5GHz band. It makes sense; otherwise what's the differentiation from E3000? http://certifications.wi-fi.org/pdf_certificate.php?cid=WFA9933