Recent content by Artex

Well thanks all for your help! I certainly learned a lot through the experience.

This is immensely helpful! I didn't see this documented anywhere for how to read the table. So I wonder if just disconnecting/reconnecting all the coax was what resolved it - which then tells me A) the MoCA supported BAMF splitter is fine, and B) all my coax runs are fine as well, including...

What is the diagonal 701/698/698? I think that is what is throwing me off - how should I be reading this chart? I am seeing speeds in my office that are pretty close to 1Gbit now.

Well everyone, I'm even more confused than I was before. I was thinking it was the RG59 for sure, but now I reconnected everything back up and now I see this. Can someone explain this graph to me now or what this means? Is there a way to determine which device is 0-1-2?? I'm at a loss...

Test 4 - All three devices running off splitter- Moved Office MoCA adapter to attic - connected to RG6 #1 (Green) from basement splitter Moved Master MoCA Adapter to attic - connected to RG6 #2 (Green) from basement splitter Left 1st Living Room MoCA Adapter in place - connected from basement...

Test #3 Reconnected the 1st coax RG6 cable (green) coming up through conduit from basement BAMF splitter from barrel in attic - this reconnected the barrel connection between the RG6 to the RG59 coax (orange) on the other side of the barrel going down into the Office. This reconnected my MoCA...

Test #2 Disconnected MoCA Adapter from Master and brought it up to attic. Left the RG6/RG59 cable connection to my office disconnected (from previous test) Disconnected the 2nd coax cable (green) coming up from up through conduit from basement BAMF splitter from barrel in attic - this severed...

Ok folks - Test #1. Disconnected MoCA Adapter from Master and brought it up to attic. Left MoCA in upstairs Office alone Left MoCa in Living Room alone Disconnected coax (green) coming up from up through conduit from basement BAMF splitter from barrel in attic - this severed the connection to...

Ok - I will try to sneak up there tonight after work and do my tests. Thanks!

^^This. Yep, thats what I plan on doing. Figured that would tell me if the issue is before or after the splitter. Easy access to the attic and cables - just need to bring up an AC source in which to plug the MoCA into power. I'll hard-code an IP for the laptop on the same subnet as the MoCA...

Not yet - I plan to this weekend. Tough during the week with my wife and kiddo at home during the week during this COVID craziness. I'll keep everyone posted!

@flyoffacliff Is there a recommended splitter for MoCA 2.5? I admittedly am a little confused as some the Holland Electronics splitters I've looked show ranges of 5-1675Mhz while my current BAMF MoCA splitter goes up to 2300Mhz. In addition, when comparing a few of these, each have a different...

@jrmtz85 & @Booboo22 This is what the thinner cable looks like in the attic as well as the end connector. You can also see the barrel connecting the (what I think is the) good cable with the cable that says VHF/UHF that runs from the attic down into the walls of the rooms where the two upstairs...

All good thoughts as well. I've been trying to 'boil the ocean' instead of narrowing it down which should be easy enough to accomplish.

Thanks! So essentially I'd be testing the connection through the filter and splitter all the way up to the attic before each splits off the barrels using the cables of unknown quality. Makes sense! I'll bring a laptop up there - just need to find an AC power source or get an extension cord.