Recent content by b-rubble

It could be different for XT8 but I will provide ET8 example; It is not possible to enable "Ethernet Backhaul Mode" if you are in AP mode as that toggle is locked down. It is only an option if you are in AiMesh mode.

nvram get odmpid: ZenWiFi_ET8 nvram get productid: RT-AXE95Q

Check AiMesh tab - System Settings and make sure ethernet backhaul mode is checked. I'm wondering if the unit is trying to sync to a non-existent 2nd unit and reclaiming your 5-2 band in the process. Check AiMesh tab - System Settings and make sure ethernet backhaul mode is checked. Maybe...

If you go to “Driver & Tools” and then “Please select OS - Windows 10 32 bit” you will see the new firmware. I found that Window 10 32 bit usually has the latest version more often that the other options listed.

Confirming this is still a problem with Merlin 386.2.2 on RT-AX88U. My Comcast primary WAN went out 30 minutes ago and I just sat here and watched the GUI show the Primary WAN as "Disconnected" and my Secondary WAN as "Hot-Standby". Wouldn't switch over to secondary until I went into the WAN...

Set to 160 and it will force it. 20/40/80/160 allows the router to decide what it thinks is best for you.

Is Channel bandwidth set to 20/40/80/160 or 160?

I also had this same issue with by 1GB comcast / CM1000 docsis3.1 / AC-5300 combo. Every single time I would restart the router I would get the ISP DCHP not functioning issue . Screwed around with the router config for several days until I discovered the problem was the modem. The solution...

I too had this same issue with my AC3200 but it did not appear to be based on distance. Randomly I would not be able to connect Apple devices (iphone and ipad) just as described above. Resetting network never solved it. Never seemed to impact clients other than Apple. Only solution was to...

Thank you for the response. I am a confused now. I was under the impression the desire was to be on a channels that ARE NOT shared by other nearby routers. Example: right now I have 1 neighbor on channel 6 (-78db) and one neighbor on channel 8 (-84db) but my router is again auto-choosing to...

I have noticed that my Auto Selection Control Channel is always 6 and single channeled at 20 mhz. Every time I check my site survey, it continually shows that channels 1 and 11 have very weak or no neighborhood traffic, and 6 has multiple hits with strong signals. The results are similar for...