Recent content by Beefcat

Hey, What is surprise. Good knowing that you visited this part of the world. I've been very fortunate and stay on the East side (Coast - Durban) where temperates through out year is much better than the high veld etc.. very cold in winters. I can't handle that. Internet is growing a lot...

@ApexRon and @ColinTaylor, Thank you for the information. Sorry for only replying now. Took me a while to get CAT7 cables. I have 2 and test them. Well, let me just say, both CAT7 and CAT 6 cables work. CAT 7 does not make a difference !. I know you probably scratching heads, or maybe it is...

Hi Colin, I have order 2 CAT 7 cables and will test once it arrives. In the meantime: 1. What is M&M Config ? 2. I have ssh into the router and executed nvram show. The following values for CTF comes up: ctf_fa_cap=1 ctf_pt_udp=0 ctf_fa_mode=0 ctf_disable=1 ctf_disable_force=0 To enable CTF...

Awesome, this help. Ok are you saying I should get a CAT 7 cable for: 1. Connection between ONT/Model and Router, 2. Connection between Router and my PC. Just want to make sure. Cable between router and Model is very short, and I need about 6 metro cable between router and PC. Then we test...

So with this routers I would not have HW acceleration issues ? and with Asus Merlin running ?

Hey Apex, yes I definitely have 384.13_10. How would I know it is a CAT7 ? Problem is if I stick the LAN cable into the ONT or Modem to my computer I get 950Mbps. If I stick the LAN cable in to router to my computer I only get around 300 Mbps. The cable between ONT/Model and router is...

thank you, if the router is problematics, what other Asus router do you recommend then. I need simular features on the RT-AC87U with Qos, AIProtection and traffic analysis. but I definitely need full speed with the LAN cable plugged in to the router up to 1 Gpbs. One that does not have this...

H Ok, you can get the syslog.txt file here :https://pastebin.com/XV8PBge7 What should I set LAN> Switch Control > NAT Accelaration to ? Auto or disabled ? If I set it to Disabled, then Tools > HW Acceleration = Disabled (by user)

Ok, you can get the syslog.txt file here :https://pastebin.com/XV8PBge7

Turning router off for a few minutes and then on did not work. Still getting Hw Acceleration " Disabled incompatible with" but it does not say with what . @colin: No I did not make any changes. @Coling how do I extract my syslog from the router to upload it to pastbin.com ?

Hi Colin and others, Please can you help, I'm back here again: This time HW acceleration is Disabled. Last time I had it "enabled (CTF only)" and I got speed up 950 Mbps. Now I'm back to speeds of 300 Mbps. Can you perhaps point me in a direction where I can try and resolve the matter ...

ah, I see. Will the new routers have that capability ?

Hi Colin, You are a guru !!! After resetting this is what I see. Test speed give me now 950 via LAN !! NOTE: On my 5G wifi I only get 485 Mbps. Any reason why I'm not reaching 900+ Mbps ? Thank you so much for helping me !!!

Hi Colin, Thank you. I will switch it off for a couple of minutes and then on again. I will also pull the power plug.

Thank you so much for the effort and help. You are correct ! How do I fix it ?