Menu
What's new
By:
Filters Better Search

Recent content by cabbagepatchkid

  • SNBForums Code of Conduct

    SNBForums is a community for everyone, no matter what their level of experience.

    Please be tolerant and patient of others, especially newcomers. We are all here to share and learn!

    The rules are simple: Be patient, be nice, be helpful or be gone!

  1. C

    DSL-AC68U no 'WAN' tab in traffic stats using ethernet WAN

    Hi, I have switched from using the DSL-AC68U built in modem to using a BT Home Hub 5. I have setup the AC68U to use one of the ethernet ports for its WAN connection to the Home Hub and all is working fine. I have noticed since doing this that the 'WAN' tab has disappeared from Traffic Monitor...
  2. C

    Prioritise subnet in QoS

    Hi, My N66U's LAN IP is 192.168.1.1 and I have a subnet 192.168.2.0 which is used for a gaming devices such as a PS4. Will these QoS settings (screenshots attached) prioritise traffic to/from the 192.168.2.0 subnet above everything else? I suppose for gaming the packets are small so...
  3. C

    How to allow UPnP from multiple subnets?

    Hi John, Colin. Thanks very much for your help. I altered my WAN IP and the upstream router to use 10.0.0.x range and I've now been able to set the Asus's LAN mask to 255.255.252.0 (and IP remains at 192.168.1.1) and all seems to be working fine. I can't see the error messages in the log any...
  4. C

    How to allow UPnP from multiple subnets?

    Just tried this and it won't let me set it. The error is "LAN and WAN should have different IP addresses and subnet". My WAN is set to 192.168.0.250 with subnet 255.255.255.0. The error is a bit beyond me! Any ideas?
  5. C

    How to allow UPnP from multiple subnets?

    Ah! No, I don't. It is set to 255.255.255.0. Should it be 255.255.0.0?
  6. C

    How to allow UPnP from multiple subnets?

    Hi John. If I try that, I get:
  7. C

    How to allow UPnP from multiple subnets?

    Thanks Colin, I've tried your suggestions. When I set the listening interface back to br0, I see this message in the logs: When I set it to 192.168.0.0/22 I see the following: What would the settings be for a virtual interface?
  8. C

    How to allow UPnP from multiple subnets?

    Hi All, I have a RT-N66U running merlin with the IP address 192.168.1.1. Connected wirelessly to that I have a TP-Link router running DD-WRT. This has the IP address 192.168.2.1 and there's an entry in the routing table on the merlin to this router. This all works fine except for when it comes...
See more
Top