Recent content by caduz

  • ATTENTION! As of November 1, 2020, you are not able to reply to threads 6 months after the thread is opened if there are more than 500 posts in the thread.
    Threads will not be locked, so posts may still be edited by their authors.
    Just start a new thread on the topic to post if you get an error message when trying to reply to a thread.
  1. C

    PLEASE HELP ME GT-2900

    thanks, so I will install the standard version again, it is more beautiful, because I will not have problems or loss of performance. I thought it might be a problem to install too much firmware.
  2. C

    PLEASE HELP ME GT-2900

    thanks
  3. C

    PLEASE HELP ME GT-2900

    another doubt and last Firmware problem, when installing the firmware and restarting, I can go back and install other previous versions, if I want. or all of these firmware installations accumulate inside the router using memory or the like. I used the standard version of asus Version...
  4. C

    PLEASE HELP ME GT-2900

    OK thanks, I thought that only my router had this defect, you even said that your tp-link also happens that way. the doubt was that it happens to others, so you guarantee that my router is not having any manufacturing problems.
  5. C

    PLEASE HELP ME GT-2900

    thanks in fact, in Brazil, even this gt-2900 router is very expensive, i was afraid it might be defective. look at the printout, the router measures right for a while, but when it starts measuring wrong, you have to turn it on and off to normalize it. or does not normalize. different photos...
  6. C

    PLEASE HELP ME GT-2900

    the router has the right measurements, even for hours or minutes, but there are times when the value of a result is less, it seems without strength to test, turning it off and turning it on stabilizes, but minutes or hours later it measures wrong again. sir, you are telling me this is normal...
  7. C

    PLEASE HELP ME GT-2900

    SORRY I AM FROM BRAZIL . MY ROUTER GT-2900, has an internet speed meter - speedtest inside the firmware, but , whenever I am going to measure the 200mbps mark. but my internet is 350 Mbps, turn router on and off, back to normal, that's 300 Mbps, right. every time I have to turn the router on...
Top