Recent content by chris n

what guide r u following? do you have a logical flow of how the traffic is going? does this stuff support UPNP and port triggerin?

good News!!!! ASUS sent me a new rtr :) , they also approved the RMA on the 5300! Asus USA gets a 10 out of 10 from me!

after FW was reuploaded the radios are working as expected: note. when it was broken i had 2 5GHZ radios in the configuration page,now only 1 after reflash

that fixed it. upon reboot after second flash the NICs were placed properly and the WAN connection is the wan connection .

no worries, all that info isnt going to be production. will be changed; i found this line in NVRAM. do you guys know how the WL interfaces line up with SSIDs? im thinking i need to add the sub wl interfaces to below. lan_ifnames=vlan1 eth1 eth2 eth3 wl0.1 wl1.1

attached show nvram.

admin@RT-AC88U-C860:/tmp/home/root# admin@RT-AC88U-C860:/tmp/home/root# admin@RT-AC88U-C860:/tmp/home/root# admin@RT-AC88U-C860:/tmp/home/root# iwlist -sh: iwlist: not found admin@RT-AC88U-C860:/tmp/home/root# iwconfig -sh: iwconfig: not found admin@RT-AC88U-C860:/tmp/home/root# robocfg show...

Hey guys!, im super excited,i finally got my AC88U to connect to the internet, albeit, WAN port is defined as port 4. Wan PORT shows up as eth0. anyone else have a similar issue? normally i would not care,but im having some issues with Wiresless and DHCP(guest networks work fine!!) and this...

I cant seem to hand out a DHCP address to any of my wirless devices. i setup a 2.4 and 5ghz gues ssid and i can connect to those fine and get a IP address. but the ones i configured in Wireless, the 2.4 , 5ghz1 and 5ghz2, will not give me a DHCP address. the guest ones hand me a DHCP...

of course i bought it and the ac-5300 second hand :) . i honestly will scrape the PCB and take pictures of the schematic. honestly wanted to get more hand in hand of R/E consumer stuff, i got my bus pirate,oscillioscope,reworking station, etc.

man you should see some of the stuff ive RMA with ASUS, sometime they give me a bit of static, but its either like $80 to fix a horribly mangled CPU socket, or just a new board. ASUS RMA is like jekly and hide tho,ive had some horrible expierences back in the day. trying to get my A7v to boot...

didnt even see one, all i saw were two stickers on the screws behind the rubber feet.

cant hurt to try, asus accepted my RMA request. if they send it back well i guess ill be pulling off ICs till i get it working... lol

so your thinking its a SW issue: how would you do " ignore the abort by returning zero from the handler.." ? Ty

ty Merlin for the sanity check, in CFE the thing lets me set IP, i can interupt and get to CAT, but anytime i try to book it just loops. unfortunetaly i have a ac-5300 with the exact same issue , sounds like i might have a HW issue