Recent content by Chuck684

Thanks for your response, that may be helpful, because my setup is similar except that I am using all 3 bands with MLO. It still seems like I should be able to use all 3 though.

I'm having the same issue as the previous firmware where I lose wifi connections, some clients still show as connected even though they are not. I've also seen where all the SSIDs dissapear as well. Wired connections continue to work. I have MLO set on the main network for wifi 7 devices then...

I've had the BE96u for quite some time, when I upgraded to the 3.0.0.6.102_39112 firmware I had all bands drop about once a day requiring a reboot. I tried a factory reset but same issue. Reverted back to the previous firmware and things have been stable ever since. I've been waiting for a new...

I would say it's finicky. Mine took several tries for it to eventually stick. Eventually I was able to get it to stick at 320Mhz. I don't believe I have any interference around either. All of mine said SP mode available as well. Still keeping an eye on mine. I just noticed mine went back to low...

That apparently didn't work for some reason. I keep seeing this: Nov 6 17:28:23 wlceventd: wlceventd_proc_event(685): wl0: Auth F8:17:2D:4C:8C:C4, status: Successful (0), rssi:0 Nov 6 17:28:23 wlceventd: wlceventd_proc_event(645): wl0: Deauth_ind F8:17:2D:4C:8C:C4, status: 0, reason...

Ahhh I found it. It's under the Network tab then down at the bottom it can be enabled!

How can I deny a single device? I can't seem to find MAC filtering anywhere in the Web GUI. I have a single rogue device that keeps trying to connect. It appears to be a Tuya device which I'm not sure I even have. I've seen other discussions on this.

I've been searching google and these forums for an answer to this. I recently setup MLO on my main network and I have seven wifi 7 clients connected. I have a Pixel 9 Pro, Pixel 9, Pixel 8, 2 Be200 and 2 Qualcomm 7800 clients. When I go into wifi properties of any of them I only see ONE band...