Recent content by ClockerXP

Man I was excited until I read your 2nd sentence. What's special about Instant Guard and why does it prevent notifications?

Were you ever able to remotely connect to your Arlo local storage via VPN?

Thanks! The full factory reset did the trick. Unfortunately I had to re-do all my settings, port forwarding, dns, vpn, etc. because reloading a config file created in 385.2 or 387.x resulted in the same problem. Nonetheless..everything's good now. It had been forever since I did a factory...

Thanks. Can you let me know what modem model/brand? Netgear? Does enabling Parental Controls / Webb apps block your access to the admin page?

Hello- I have a Netgear CM3050V EMTA cable modem. I'm currently running Merlin 386.5.2 on my RT-AC86U. If I try to upgrade to 386.7 or 386.7.2 of Merlin, access to my cable modem at 192.168.100.1 is all screwed up and I am unable to veiw the signal levels and all kinds of other options related...

Just updated my RT-AC86U to .19 from .17. I did backup the JFSS beforehand, formatted it at the next reboot, reflashed it, and then rebooted it again. I don't really use any custom features except for OpenVPN which seems to be working fine. Are there any issues I should watch out for?

Howdy- I have an RT-AC68U. I was looking at getting an RT-AC86U for the increased VPN performance. I got one from Amazon but the 2.4ghz radio was dead and I have been reading a lot of horror stories about quality problems with this router. So for now, I am just overclocking my 68U. Is...

Thanks for the heads up Merlin. Noted!!

Anyone try the koolshare Merlin firmware before? Or maybe this? [link removed. -rm]

I have one of thes R7960P routers. I was a beta tester for it in the winter. I would love to use it again but I need all the features I have in the Merlin firmware with my Asus RT-AC68U. Any idea if this router may get some Merlin love? Specifically I need good OpenVPN support.

Thanks! I will wait for 384.5!

Hello. New here. I have two RT-AC68U's (actually T-Mobile Routers I flashed over) running the 380 firmware. They are both on the same network...one is a router and one is an AP. What is the recommended method for upgrading both to 384 and doing a full reset? If I do a full reset and both...