Recent content by ColinJOnes

I posted as I didn't know how to clear the log file without deleting it and unfortunately I don’t know how to search for binary characters or even know what they are. thanks for you help though. I resolved by stoping the service, deleting file and starting service again

Hi, I am trying to use the autoscan.sh script that comes x3mrouting and am getting an error. This is the command I am running but it doesn't work (It doesn't work when I search for anything). ./autoscan.sh autoscan=netflix I do have these lines in the dnsmasq.conf.add file and the dnsmasq.log...

I didn't think I needed to remove the rules but within Domain VPN Routing when I look at the config (option 5) the WAN0 FWMark and WAN1 FWMark aren't editable as they are under the "System Information:" section so I tried removing the IP Rule's.

Hi, I am using OpenVPN. I have removed the FWMark from the router by running these 2 commands ip rule del fwmark 0x80000000/0xf000000 lookup wan0 priority 150 ip rule del fwmark 0x90000000/0xf000000 lookup wan1 priority 150 Now when I run tracert to a domain added to a Domain VPN Routing...

Hi, I am using your Dual Wan Failover in Load Balance mode and this seems to work really well with the latest update. I am though having issues with Domain VPN Routing, I have Nord VPN configured in ovpn1 and Domain VPN Routing works fine if I only have either one of the internet connections...

I'm not sure how to solve it or if it's even possible. I have Dual wan and my ADSL (70 mbps) needs to be the Primary as its also used for IPTV and I also have a 1GB Fibre Connection and I'd prefer to utilise the 1GB conenction.

Would it be possible to add an option for which WAN interface to use for the VPN Slot if people are running Dual WAN in Load Balance Mode.

Hi Again, I've installed v2.0.5-beta2 and I have been testing. Test 1 - Unplug LAN cable from ASUS Router (eth1) ============================= When I unplug the LAN cable I can see when checking the Routing Table that the routes get removed and my computer fails over to the WAN interface...

Thank you for the speedy reply. I have installed the new beta build and it’s running now but I do have a couple of observations. I have my dual wan configured in Load Balance Mode as I want to be able to choose which of my 2 links different devices use based on Routing Rules. If I disconnect...

Hi, I have tried to get your script to work on my XT12 router and not having much luck. when I enable the Debug logging in the Router Admin page I then see constant mentions of the following wan-failover: Debug - failed to set WAN0USBMODEMREADY I'm wondering if this is because this Router...