Recent content by cybergibbons
-
Unable to set WPA2 on guest networks
I have setup a number of guest networks on my Asus RT-AC66U running Merlin as an AP which route via various VLANs to my router. They work fine if either: a) They are set to not use any encryption (open). or b) They use encryption but bridged to br0 (vlan0/eth0/wl0.1/wl1.1). If I move them...- cybergibbons
- Thread
- Replies: 0
- Forum: Asuswrt-Merlin
-
Obtain address for br1 via DHCP
Thanks - that appears to do the trick.- cybergibbons
- Post #3
- Forum: Asuswrt-Merlin
-
Creating virtual wireless interfaces outside of UI
Yeah - I just came to the same conclusion by diffing the nvram settings. Script time :)- cybergibbons
- Post #5
- Forum: Asuswrt-Merlin
-
Obtain address for br1 via DHCP
I currently have my RT-AC66U being used as an AP only on a secure network and a guest network, using VLANs and an external router/firewall. The VLANs are setup as follows: root# robocfg show VLANs: BCM53115 enabled mac_check mac_hash 1: vlan1: 0t 1 2 8t 2: vlan2: 8t 4: vlan4: 0t...- cybergibbons
- Thread
- Replies: 2
- Forum: Asuswrt-Merlin
-
Creating virtual wireless interfaces outside of UI
What I means is that through the UI, you have the ability to create virtual wireless interfaces on the "Guest network" page: These show as wl0.1 (2.4GHz) and wl1.1 (5GHz) through ifconfig: wl0.1 Link encap:Ethernet HWaddr 74:D0:2B:88:AC:D9 UP BROADCAST RUNNING MULTICAST...- cybergibbons
- Post #3
- Forum: Asuswrt-Merlin
-
Creating virtual wireless interfaces outside of UI
I'm not keen on only being able to do things through the UI. At the moment I am using my RT-AC66U to take three VLANs in via the WAN port and split them to three distinct 5GHz WiFi SSIDs. No routing is done by the RT-AC66U at all. The only way I have found to create these wl virtual wireless...- cybergibbons
- Thread
- Replies: 4
- Forum: Asuswrt-Merlin
