Recent content by cypr919

Thank you all for your replies, I will report back once the new cable arrives and use it for a while.

I restarted the Asus router and on initialization I checked the logs from the ZTE, the message logged is '[system][notice]Lan eth0 pulling out '. I doubt the cable is the problem. Nevertheless, I ordered a new cable to eliminate this possibility.

I didn't redact any IP addresses, they appear as such by default (that 10.xxx IP is the CGNAT one). Now I disable UPNP once it was mentioned and the issue remains. Moreover, replaced the cable connecting the Asus router and the 5G modem POE injector, basically the hardware setup is: ZTE MC889...

I will try setting auto logout to 0 now. Also the CGNAT IP has remained the same for days now.

The issue occurred minutes ago. Please find attached the logs from the ZTE device and the Asus router. The timestamp should be around 2023-10-24 21:25:25, and from the ZTE device I notice the following status '[system][notice]Lan eth0 pulling out '.

Hey, thanks for your reply. I tried using the 1GbE port as the primary WAN (dual WAN setting), but the issue remained. Furthermore, I experimented with all three DHCP query frequency options: aggressive, normal, and continuous. Additionally, I disabled IPV6. As for the logs from the ZTE device...

Greetings, I recently purchased this router and initially had no issues. However, for about a week now, I have been experiencing multiple disconnections per day, accompanied by a generic 'ISP DHCP not functioning properly' message. Furthermore, I am using a 5G modem (ZTE MC889) with an Asus...

Thank you for taking the time to respond to me, this helped and I can see it in the interface now.

I tried that and I still can't see it in the menu. Edit: I did a hard reset on the router, re-installed the script, and I still can't see it.

Hello, I installed FlexQoS on my newly purchased Tuf-AX5400 but I can't see the FlexQoS tab in the QoS section of the GUI, any ideas ? Thank you in advance.