Recent content by DaKo25

Update: the bad signal between the two device (backhaul) seems to be cured. I narrowed bandwidth on the 5Ghz backhaul band to 40, Smart Connection disabled, WIFI Agile Multiband switched on, and Roaming Help disabled. Backhaul is steady for 4 days now. I disabled the nightly restarts (which I...

I have stopped smart connect on the router, because my smartphone was switching back and forth from 2.4 to 5.1 Ghz network. Now the ssh command gives me a log without the connect-disconnect lines. Coincidence, or is there a relation between switching of smart connect and the log entries? edit...

Well, my issue in this topic is not the connect-disconnect lines. I just mentioned them as a result of your suggestion to run the SSH log command. Or do you think the connect-disconnect issue is related to my instable backhaul connection?

After analysing the WIFI channels in my surroundings, I choose manual channels, set band 20mhz for 2.4 GHz and 40 MHz for 5 MHz. For Backhaul I cannot select channels outside the Dutch DFS-channels. I do not understand that, because there is also an option in the settings to disable the use of...

On the webpage of Asus they suggest a distance between 3 and 5 meters. They say: the closer the better, and the more direct line the better. So I do not understand what you are trying to solve with increasing the distance?

So, I am one step further. I know now to connect to the extra node with ssh. What do I do with the results from the command tail -f /tmp/syslog.log? I see continuous connection and disconnection lines in the log. But it tells me nothing.

I am trying to figure this out. I turned on the ssh. I think I need to connect to the node by wire right? Not by WIFI. And do you mean the extra node or the main router? And where do I type the code? I am sorry, but I never worked with SSH, new on that part...

I am in The Netherlands :). And tweeking the channels I already tried. Now I moved my node to the third floor. But again, after a few hours, my connection went down from good to poor and my internet is stuttering. I have great connectivity to the node thought, so I suspect the poor backhaul...

I have to buy a new house...:)

I understand. My physical internet connection (and thus the main router) is in the center of my house on the first floor (ground level). I put the node 1 level up (second floor), about 7 feet off, horizontally. If you suggest to decrease the angel between the main router and the node I see no...

It used to be 5 m apart, and I moved it closer to each other to try to solve this issue. I could try to place the extra node on the third floor. Can you explain why this can help? The closer they are, the better signal strength right?

I update the firmware consistantly. Now both nodes are on 3.0.0.4.388_24710 Yes, I disconnected and added the node again. (no result) I have reset all to standard settings (no result) tried to figure out if lowering the transmitting power helps (no result) I changed locations (no result) There...

Hi all, I found this forum while searching for help with a very annoying issue with my ASUS ZenWifi AX. The wireless backhaul option have never worked without issues from the beginning. I have the main router (first floor) and 1 extra node (second floor). In a direct line only 3.5 meters apart...