Recent content by dasdfarmer

  1. dasdfarmer

    AIMESH and Macbook Pro Issue

    Too much Wifi for the Mac? That is interesting. This config was working great until recently. I don't remember the sequence but we upgraded the routers firmware and around the same time upgraded the Mac to Monterey. Then the problems began (Mac Only). I Scheduled the daily reboots a while ago...
  2. dasdfarmer

    AIMESH and Macbook Pro Issue

    Thanks for the response. The AX11000 is currently at firmware level 3.0.0.4.386_45934-gb23bdac The 2 AX92u's are at firmware level 3.0.0.4.386_45934-gb23bdac The nodes were completely reset when I did the firmware upgrades a while ago. My SSID is not short (10 alphanumeric characters). There...
  3. dasdfarmer

    AIMESH and Macbook Pro Issue

    My current setup is: Metronet Fiber | AX11000 | | AX92U AX92U The Asus devices are currently running the latest Asus firmware. The Macbook is getting anywhere from 5-20% packet losses when...
  4. dasdfarmer

    Went to new Faster Internet Service, Wifi slower.

    Thanks for all of the information. I turned off the AIMESH nodes and tested Wifi close to the AX11000 and got 6-700 Mbs up and down over several tests. Turned the mesh nodes back on and at the Meshnodes, I am getting about half that speed. Prior to installing the new network provider, I was...
  5. dasdfarmer

    Went to new Faster Internet Service, Wifi slower.

    When I say wireless at the AX1100, I meant that I was connected wirelessly to the AX11000 and not to one of the mesh nodes. .The speed test is using multiple connections.
  6. dasdfarmer

    Went to new Faster Internet Service, Wifi slower.

    Wired Latency runs 1-2 ms. Wireless at the AX11000 is 2-4 ms. There may be other wireless traffic going on when I run the tests. Note with my previous internet provided the latencies where much higher, in the 15-20 ms range, wired or wireless.
  7. dasdfarmer

    Went to new Faster Internet Service, Wifi slower.

    Went to new Faster Internet Service, Wifi slower. Greetings, I am currently running a GT-AX11000 router with 2 AX6100 mesh nodes. All nodes are running the latest Stock Firmware. My previous service provided 400 Mbps Download and 30 Mbps upload and I was generally able to see this speed on most...
  8. dasdfarmer

    AIMESH Network Stability

    I did a hard reset last night on the 2 AX92u's and 3 hours later we had a crash. In this case, rebooting the AX92u nearest to us fixed the issue. In the past we have been rebooting all of the routers when the event occurs.
  9. dasdfarmer

    AIMESH Network Stability

    Thanks for the advice, I am running the latest firmware on the AX6100's and They have both been reset as follows: 1. Remove them as nodes 2. Pressed reset button until the power light flashed 3. Added them again as nodes. Should I do the hard reset via the WPS method? Best Regards
  10. dasdfarmer

    AIMESH Network Stability

    Thanks for the input. I will review the information in the link you provided. When I indicate that the new mesh system performs better than the previous. I was referring to network speeds. The previous network was slow in the places in my house that were the farthest from the nodes. The new...
  11. dasdfarmer

    AIMESH Network Stability

    Greetings, I recently created an AIMESH network with AX11000 as the Main node and 2 AX6100's as mesh nodes. All nodes are running the latest stock firmware. My current internet provided is Spectrum and I am using their modem for internet connection. The system performs much better than my...
Top