Recent content by DigitalSnow

What is the correct step to test out this config? I added this to the hw_probe.sh and re-ran hw_probe then install.sh (the asp page did not update unless I rerun install). I was hoping to see the labels, but they did not show on the page. Are the hyphens and underscore not allowed? Thank...

Yes, ETH0 is the primary WAN port, however, the router has two that are labeled and are selectable as the WAN port in the settings (LAN 1 - 10G and LAN1 - 2.5G). Be happy to gather more information or run some tests if ever needed.

Not sure how many models will be like this; the script does not work for the GT-BE98 PRO as it has the 4 x 2.5G ports all sharing a single eth interface behind an internal switch. Here is what I have determined using `brctl show`, `ethtool`, and `ip link show`: eth0 = LAN 1 - 10G eth1 =...

@L&LD Appreciate the follow up and doc link, though I did a fresh install and reconfigured from scratch. (factory reset, no usb, no entware, no scripts). Other than my configuration via the UI, the only change is adding YazFi.

Unfortunately, I have not had time to tinker around much yet, as I just made the changes last night and was prioritizing getting a working state. Sad to hear that guest #1 sometimes has issues; had been using it without issue on a 2018 version of 384 for so many years.

With this upgrade `386.5_2` I too am having issues with the Guest network. Fresh install on RT-AC68U. Though, I cannot compare to any other recent version as my last version was about 2 years old. Issue: connection attempts to the guest network fail from all clients. The only way I have been...

Since upgrading to 378.54.2 I have been unable to load the USB Application page for my router. The page just says Updating... indefinitely. I am still new to this process and am not familiar with troubleshooting methods. My USB drive is still accessible through SMB with the settings that I...