Recent content by DougA

Nothing looks out of the ordinary. Not too much traffic, cpu usage is low, internet seems to be working fine. When it gives me the ping times for each WAN, what is it pinging? Can I try pinging it through the command prompt and see if I am getting the same results?

@Ranger802004 Any idea why I keep getting these messages in the log? My pings to 1.1.1.1 and 8.8.8.8 are fast when I ping normally. Feb 2 20:26:13 wan-failover: Ping Time Below Maximum Threshold: 80ms - WAN1 Ping Time: 40ms Feb 2 20:26:35 wan-failover: Ping Time Above Maximum Threshold: 80ms...

I plugged the secondary WAN in again and this time it seems to be working. Primary WAN is up and Secondary WAN shows as Hot Standby. Thanks for the script, nice work.

I have another thread with questions regarding WAN 0 and WAN 1 issues, but figured I would post it here in case others have a similar questions. I have everything installed and working, with one exception. When both WAN interfaces are connected, it shows the Primary WAN as Hot Standby, and my...

@Ranger802004 It appears everything is working except two items (see below). Can you or anyone else provide any guidance? My Primary WAN shows as Hot Standby and my Secondary WAN shows as Connected. Can I simply switch the ports they are plugged into my router so my Primary WAN is the main...

Great information, thank you. I have everything installed now, and have done the initial configuration. Haven't tested it yet, but that will be next. Here is my current config, see any issues? Questions: What is option 17 & 18 "Web GUI IP Address"? Should I turn on NVRAM checks? What...

I've installed the latest Merlin Firmware on my Asus Router and then did a full reset. I set things back up for my primary WAN which is working fine. I then connected via PuTTY and installed Dual WAN Failover V2. Everything seemed to install as planned. Questions: Do I need to configure...

Thank you. I did have the issue to start, but not sure that is still my issue. I will review further though, I appreciate the help.

Will do Ranger, thank you. I will hopefully have time to try it out this weekend.

Thank you.

Thank you Kingp1n, I may try installing Merlin firmware this weekend. I'll also check out this script, it sounds like it will do what I need. Noob question for you though, what is AMTM?

Thank you for the reply and for letting me know. I still might upgrade the firmware to Merlin, but it sounds like that won't fix my issues.

I found this forum when searching for Dual WAN issues on my ASUS ROG GT-AX11000 router. I have a cable internet as primary WAN, and a T-Mobile Hotspot (via Ethernet) connected as a Failover Secondary WAN. It took me awhile to get things setup correctly on my Inseego M3000 T-Mobile Hotspot, as...