Recent content by dpjanda

Hello forum I don't know if this is possible, but here goes.... I have a VPS, I want to route *inbound* port 80 traffic through OpenVPN to my N66U. Then, I want to point that traffic to a specific server on my network. Also, I want to return content via same route. In other words; I want the...

http://www.smallnetbuilder.com/forums/showthread.php?t=15620 Regards

See my post on PPTP selective routing / Split Tunnel. The script posted on this thread will not work with PPTP. It's for OpenVPN. Regards

Hello there See my re-edited first post. Try the new method and see if it works for you. The original method of tearing down, and then bringing up the VPN interface was, to say the least, a little brutal. It ^could* have affected your DNS issues, but I don't know for sure. My...

Following on from the thread on selective routing with OpenVPN, I am providing a similar solution that works for PPTP VPN client connections. This post details the method and a simple PPTP start-up script. In a following post (few days as am busy) I will post a more detailed script that...

Hello Merlin I am not looking to host anything with the built in server, but to tweak specific settings relating to certificates. I have installed my own cert that is used by the web interface and AiCloud, but am not happy how lightppd offers ciphers. Just wanted to tighten up things a...

Does anyone know if its possible to alter the configuration file for the built in server? I want to alter some settings. I know its possible to install lightppd, but that's not what I am looking for. To date the only way I can see doing this is to take a snapshot of the config, copy and...

Is this a bug? When you start a PPTP VCPN client session, an endpoint and default gateway are created like this: Destination Gateway Genmask Flags Metric Ref Use Iface 192.168.5.1 * 255.255.255.255 UH 0 0 0 eth0 78.x.x.x...

!!! I have cracked it !!! For those interested, I have managed to get selective routing with the pptp client fully working! Further, the solution allows all services on the router to be used as normal - eg AiCloud, Transmission - and you can access them remotely. I will be putting up a...

No. Honest! In fact, the example I gave was done via command line. Anyway, after an afternoon messing about with it, I think I will have to revert to the original script and see what I can d with split tunneling. Regards PS. Even running it as a shell this comes up...

Ah thanks for that Martineau Alas the script by DJR747 appears to be very specific for OpenVPN, and adapting it for use with the PPTP client is beyond my scope! Tried, just for the heck of it, and got some interesting errors: someone@RT-N66U:/jffs# ip route flush table 10 Nothing to...

Split Tunneling I have a question. I have adopted an earlier script on page 4 of this thread to work with the PPTP client. And it works! However ..... Upon noticing on the thread, and with my own testing, you cannot get access to the router (AiCloud etc) when the VPN is active...

Hi Thanks for that, but that's not what I am looking for. I need a way to start the PPTP client at boot. Unlike OpenVPN, there is no option to run at boot/WAN start. That's my sticking point. Routing wise, I have got all that. Just need N66U PPTP client to run after a reboot. Thanks.

I take it you are referring to the scripts that were recently posted? I will give it a go. Hope it works. Before I start, can you or someone else tell me how to start the pptp client from a script, as it does not start on reboot. Thanks.

Hello Does anyone know if this is possible? My ISP does not support OpenVPN for its VPN service. RT-N66U Regards to all.