Recent content by dragon31337

I've flashed FW_RT_AC88U_300438648313, reset to factory, and added AC88U as a mesh node without a hiccup... Thank you, everyone.

I do not overcomplicate it, I'm the one who will be managing it, and I was thinking runing firewall and ads removing and monitoring scripts, that would make my life easier. I'll try latest native asus FW on the node.

It would be just so easy if I had both merlin ones. And that is how it's setup at my place with AX11000 Pro and AX88U in my place, I'm just trying to duplicate the setup at my inlaws with AC5300 and AC88U

I do not even know where to get the matching FW for AC88U, is ASUS RT-AC88U Firmware version 3.0.0.4.386_48313 fine? Do I just flash it back via the UI, no tricks?

Maybe it's a timeout thing and node goes back to the router mode after it, I do not know. When I connect back to then node over LAN, it gets me to the login page with admin/admin credentials where it says that AC88U runs in wireless router mode.

I eventually managed to see it but when the progress of adding the node started I endup getting this after 16% of adding node over ethernet: I do not get what is wrong, both are on the same version

I tried, my process was this 1) Laptop to Mesh node connected over LAN, freshly refreshed 2) Main router was reset, set as Wireless router mode, went through setup and works fine, LAN IPs are on 192.160.0.X network, laptop is ready to connect as soon as I unplug the cable connected to the AI...

I'm trying to add AC88U as an AI node to freshly setup AC5300. Both are on 386.14_2. AC5300 just does not see it available. I can see it's plugged and on 1GB speed on LAN stats, but when I look for nodes - nothing. Cablle is going from LAN1 on AC5300 to WAN port on AC88U. I wonder if that...

I've been tracking the state on the status page, and it stays on 1GB for a while, one day on average. Sometimes 10 hours, sometimes 2-3 days. I do not have a clear solution to the link rate, at the cable is already shielded cat6, high quality, grounded, etc. Resetting it would be a good enough...

I'm running my network on AX11000 Pro and there is a relatively long cat6 cable that goes to the attic to serve a switch on the second floor which would be a hassle to replace and it won't guarantee any changes. The problem is that that link stays on 1GB speed for about a day or two. Is there a...

After some time (1d 16h) stats and ports status do not show up for my AX88U log looks weird too UPD: I've logged out and logged in and it works now. But I did refresh pages before and it was empty

Would it be any difference if I swap?

What's the point of enabling the firewall if it constantly crashes? =)

I disabled the firewall to avoid those crashes for now.

I keep getting these on my AC5300 with AIMesh on AX88U node: