Recent content by dsring

Does this script work on all routers running Asuswrt-Merlin firmware version 3006.102.# ? I have the newer GT-BE19000AI running Merlin 3006.102.7.

It may be specific to your environment, or a hardware defect with your router. 2.4GHz works fine on my GT-BE19000AI. Wireless signal is on par, or better than what I had with a RT-AX86U_Pro with 2 mesh nodes. I replaced all three devices with the GT-BE19000AI. During the initial setup, I set up...

I had a few issues with the GT-BE19000AI version with this beta. Around 36 to 48 hours after flashing this beta, I lost the wired connections to my Synology NAS and Raspberry Pi. They both showed connected on the GUI dashboard, but they both had to be rebooted to restore their internet...

HW acceleration is enabled for me. Most likely this is why your download speeds are affected.

Installed on GT-BE19000AI. Everything seems fine. The only thing that I have noticed is the Wifi Insight section on the Dashboard is not updating...same on Edge, Brave, and Firefox browsers.

Tried to install and run the ControlD Command Line Daemon (https://docs.controld.com/docs/ctrld). The script appears to install properly. When I try and start the ctrld service, I get a "ctrld: not found" error. I reverted to 102.6 firmware and everything works as expected.

Dirty upgrade on RT-AX86U Pro. Working well. No issues. Looks good on my end.

Just curious if you factory reset after updating to this version. I am thinking about flashing this version, but I don't want to go through the process of setting everything up after a factory reset. I will be updating from Asuswrt-Merlin 3004.388.8_4.

Does vpnmgr work with the 388 series of Merlin firmware?

Firmware is stable on RT-AX86u, but router did reboot when disabling Wireguard. I also am getting an error code 73 when trying to access Disney Plus when using WireGuard VPN that I do not get when using OpenVPN.

Flashed to my RT-AX86U. Performed a hard reset. Reconfigured and everything seems to be working well. I tried to disable Spanning-Tree Protocol, the router rebooted, and it re-enabled itself. Disabled it again with same results.

Same here...high CPU usage with vpnmgr. I uninstalled it and CPU usage was still high until I rebooted the router.

When you enable Wireguard, does it disable hardware acceleration on the router? Which I assume that WAN speed will be limited to around 350-400 Mbps when enabling Wireguard??

GUI issue fixed, following these instructions. Thanks.

Same GUI problem. Is there a fix?