Menu
What's new
By:
Filters Better Search

Recent content by dudeman33

  • SNBForums Code of Conduct

    SNBForums is a community for everyone, no matter what their level of experience.

    Please be tolerant and patient of others, especially newcomers. We are all here to share and learn!

    The rules are simple: Be patient, be nice, be helpful or be gone!

  1. D

    AC68u after latest firmware poor wan to lan

    There was no difference in performance at 800 or 1000. CTF + FA shows enabled and CPU stayed around 3%
  2. D

    AC68u after latest firmware poor wan to lan

    If I connect direct to modem, I can pull about 938 down. I could get >900 behind my router prior to this update. Now it seems to hard cap at 650.
  3. D

    AC68u after latest firmware poor wan to lan

    Yes, that's what I did on the new(er) firmware, and I tested again before restoring settings to test that as well. 800,666 is the default I believe, but I know that is what I had it at prior.
  4. D

    AC68u after latest firmware poor wan to lan

    Well that's what I did after a fresh flash. I did a factory default reset, waited, did a power cycle, and I still can't get more than 2/3 of my wan speed. Had no trouble before the upgrade, and I would have thought that a reversion and reflash to the earlier with the same steps, factory reset...
  5. D

    AC68u after latest firmware poor wan to lan

    Interesting, I would have sworn that it was _20. The one that I flashed a few days ago was: RT-AC68U_384.18_0.zip I did the nvram reset via ssh and formatted jffs, did a factory reset, etc. At this point should I recovery mode and try it super fresh?
  6. D

    AC68u after latest firmware poor wan to lan

    Hello. After updating to the latest _18 firmware, I could no longer pull my full gigabit wan to lan. It seems to cap out around 620-650. This is with CTF/FA enabled. I tried reverting to the _15 which was what was on it before, but the same issue persists even after restoring from settings...
See more
Top