Recent content by ern

Sorry if its been asked b4 but do you need to remove kamoj modifications before updating the voxel firmware ? Thanks

Hello has the download site changed - I no longer seem to be able to get to the ge.tt site

Oh no. I will have to replace my r7800 for the r9000 - Got to to have the antenna bling :)

I had a slightly different speed issue as previously reported on here with AdGuard slowing my router to a crawl after 12 ish days I have not used any addon for approx 2 weeks and my issue has not reappeared I put Pi-Hole docker on my NAS instead of using the router which has been working fine...

Hi I have a config file with all my basic settings in it. This was created before any mods or changes were done to the router So a raw router set up with my provider and settings then a config backup created This config was good for the first few months of having the router before I started...

I tried to run without addon for a few days but missed the functionality of AdGuard So installed the latest but set AdGuard to log 24 hrs only approx 12 days later same issue as above. Internet slowed to a crawl I have just done a pin reset and re uploaded my config. Which seems the only way to...

Hi Possible bug issue I will try and explain as best possible Issue takes about 12/13 days to show up and was present in kamoj-addon beta version 5.4b10 and the previous beta I had installed which was presumably 9 I have a 900 down 100 up connection I use AdGuard with standard settings. I use no...

Hi Kamoj Thanks for the info I feel its a bit too complex for my needs though. But great to see a way of backing up and reinstalling all of the port forwards It would be quicker for me to delete the 2/3 unneeded port forwards and then inputting them again when required rather than go through a...

Hi Kamoj and Voxel First thanks for the work in creating great alterations to the Netgear firmware I am new to Netgear and normally would have put DD-WRT on it had I not found your modifications I do have a request if I may - Unless I am missing something there does not appear to be any way in...

Previously reported high CPU usage with AdGuard Now woking well with the following changes to default settings In upstream DNS server addresses I removed the last 2 server address entries Then I switched from parallel requests to load balancing (this was the main culprit for high CPU usage)...

I turned off "use adguard browsing security service" (Safebrowsing) and all working OK part of error log below 2020/10/26 12:17:36 [info] SafeBrowsing: failed: couldn't read body contents for 'https://dns-family.adguard.com:443/dns-query', cause: net/http: request canceled (Client.Timeout or...

I installed AdGuard and left everything at the default settings. It worked well for the first few hrs then it became almost impossible to access the internet Logged in to router and looked at router information and found cpu maxed out Could not access AdGuard through its interface as very slow...

Thanks - Such a simple fix - I thought as my password worked everywhere else on router it should not be an issue All working now and AdGuard set up and working Thanks again

Just installed latest Kamoj for the first time on my R7800 with Kamoj V5.4b5 and Voxel V1.0.2.80.4SF Followed instructions and was able to install OK after I swapped out a faulty USB stick Kamoj menu all present and correct I can view some of the pages, Router information, settings and...