Recent content by Frankhar

NVM, had to reformat USB for some reason, anyhow, thank you again for all your great work @Voxel and also @kamoj for your terrific add-on!

Hi Voxel, Thank you again for your great work. Upon flashing the latest firmware, 1.0.2.84SF, it appears the router does not recognize my USB anymore. Since I also run Kamoj's add-on I cannot install it, I will try to roll back and see if I can fix it. I have two R7800s, one as primary router...

Thank you Kamoj, the option seems to have done the trick, didn't notice that in the sea of options. I also noticed there is the AWS disable option next to that, I assume that disable the needless AWS IOT analytics thing does the same as what HELLO_wORLD suggested in the cmd line?

What does the aws disable do? What is the aws?

I have the same QOS issue, I tried these commands from HELLO_wORLD but when the router rebooted, QOS is back on, is there some privilege elevation I am missing. I am just using telnet.

I turned off HT160 on both the bridge and main router and the issue seems to be gone, it seems HT160 is not stable for the bridge connection. It must be off on the main router too not just the bridge. It's a shame seems now there are more 160Mhz clients available but they are not fully...

I got a quick question, I recently got another R7800 to use as a bridge. It is losing connection after about 2 days of running as expected. The bridge R7800 is also running on 1.0.2.79SF, does anyone else experience such issues when using bridge mode? When the bridge is disconnected there is no...

Thanks Voxel!

Thank you Voxel, as always, great work!

Thanks Voxel and Hello_wORLD!

Thank you again Voxel for your great work, just upgraded, so far so good!

My IPV6 seems to work fine as before, my ISP supports IPV6. Thank again Voxel, big fan!