Recent content by FrizzleFry

I am aware of how vpn's and wifi work. My work computer's vpn is configured with rules to refuse connection to any wifi that is open/has no password, even if you have to put one in later via browser. Yes, this vpn actually has control of that. But if I connect via ethernet it's no problem, vpn...

I bought it on a whim, because my work computer's vpn refuses to connect to any open wifi (without a password), which is pretty much every hotel in the world. Trying to figure out WISP mode.

Looking for a definitive answer on whether there is a Merlin firmware that works on the RT-AX57 Go. I'm guessing not, but just want to make sure. Looks like the AX57 Go is DDWRT 5.0 compatible, according to this. When I look at the Asus website the AX57 and AX57 Go are different routers, both...

Just got an AC86U, and I am also wondering about these settings. I have heard that NAT Acceleration might not be helpful if your connection is below 100 mb down, but might reduce ping if turned off. My connection is cheapo 50 down/ 10 up, and I do a lot of gaming, so I'd at least like to do some...

I seems to be working well for me, but I do have a general question or two: - the readme says we should do a factory reset if we are more than 3 versions behind. I have pretty much stayed up to date, i.e. updated with every version, but haven't done a factory reset in a while (probably more than...

Ok, got it setup via Wi-Fi, we'll see how it goes.

My ports on the router are full, but I suppose I could try Wi-Fi. I haven't really looked into its configuration on the printer itself; I am a bit of a stickler for security, hope it can be set to ignore unknown mac addresses etc. But this is still a workaround, the USB connection shouldn't...

I have an Asus RT68U, and I have a brother HL-2270DW printer connected to it via the USB2 port. I have used the Asus utility to connect a couple of computers on the network to the printer, and it works ok with two exceptions: - occasionally, part of the way through the print job it will just...