Recent content by GCourtoy
-
G
No WAN with Bell 4000 passthrough
Sorry : reset + ok for bridge on. Reset + arrow for bridge off -
G
No WAN with Bell 4000 passthrough
found easy way to bridge mode : hold reset button + arrow for 7 seconds and voilà !! Same procedure to reverse. -
G
No WAN with Bell 4000 passthrough
after a few try, I realize that my hardware is getting pretty old…. I’m not getting the speed I should. Decided to go with Bell4000 as main router and switch my ASUS as access points. I loose AiMesh but get real gigabytes speed. I guess there’s no way to put aimesh on access point to buy since... -
G
No WAN with Bell 4000 passthrough
I have my network setup with ASUS AiMesh, and I don’t want to loose it. Bell Fibe as a ISP. Upgrade to 4000Giga. Before : no Bell route at all. Just the ONT box and 5e to n’y ASUS RT-AC3100. No need for FibeTV to run (I stream straight from appleTV). With new setup : fibe to 4000, wifi... -
G
Traffic monitor log incomplete
@Tech9 368.13 did the trick. Thanks !- GCourtoy
- Post #3
- Forum: ASUS AC Routers & Adapters (Wi-Fi 5)
-
G
Traffic monitor log incomplete
Hello everyone, I know RT-AC3100 is no longer supported, but I have an issue and was wondering if there could be an easy fix. I have an issue with my traffic analyser statistic. It has no memory. I only see the last 1-2 hours of activity of my clients, before that : just a flat line/no...- GCourtoy
- Thread
- rt-ac3100 traffic analyzer
- Replies: 3
- Forum: ASUS AC Routers & Adapters (Wi-Fi 5)