Recent content by genestar

Is there a way to include all the traffic generated by a client when it is connected with a open vpn server?... In my rt-n66u with the old merlin firmware, 380.70, if I was connected to the vpn, my IP address was the same as the router and I was able to browse a geo-blocked site (...blocked for...

I've made some test on the wifi schedule: for 3 days all ok (start 6.30 am, stop 11.00 pm), the 4th id didn't start up; not done any config changes or something else on the N66U... I will test the logs in the next release.

Thank you John; in the next days I will check if it woek with different hours. I don't know if could help, but I'm in GMT+1, than 0 to 24.

There's nothing in log: no "start wireless", no "stop wireless"; I find two "restart_wireless" when I manually restart. I will test the schedule with different hours.

I installed this fork on my N66 two week ago and so far so good, but there is one strange thing in the wifi schedule: I've set it to switch on at 6.30am and off at 11.30pm, but sometimes when I wake up at 7.00am I found the wifi switched off and I have to manually turn on in the config page...

Interesting... save all pages with the browser is more fast than make screenshots and the "restore" more simple; thank you, I did not think about this method.

Thank you Colin; than the "safest method" is to re-setup all the configuration manually :-(

I have an old RT-N66U with the merlin 380.70 firmware (the last available). I'd like to install this 374 LTS, but I have some doubt; I know that I must do a "factory reset" after the installation of the new one (using the firmware restoration tool or the CFE Mini-Web Server). My question: there...