What's new
By:

  • SNBForums Code of Conduct

    SNBForums is a community for everyone, no matter what their level of experience.

    Please be tolerant and patient of others, especially newcomers. We are all here to share and learn!

    The rules are simple: Be patient, be nice, be helpful or be gone!

Recent content by Gunter

  1. G

    [Official Release] AiMesh Firmware v3.0.0.4.384.10007 for All Supported Products

    I wished the app or webUI would mention that the node to search for has to be reset fully and put within 3 meters, only connected through power cord. This would have saved me (and many others I'm sure) a lot of time and trial and error. Even when it was mentioned a few times in this thread...
  2. G

    [Official Release] AiMesh Firmware v3.0.0.4.384.10007 for All Supported Products

    Yes i did before and it didnt help. When the (Netgear Prosafe 8 port gigabit switch GS108) was in between the router and node i got all issues many people had. Now not anymore. It never went offline anymore since then. If you want i can test it again with the switch and let it run until it...
  3. G

    [Official Release] AiMesh Firmware v3.0.0.4.384.10007 for All Supported Products

    Understand for wireless. But i configured it for Ethernet and i still have overlapping channels where i get less bandwidth (testing with speedtest) compared to setting it up as AP with its own channel so less collisions ?
  4. G

    [Official Release] AiMesh Firmware v3.0.0.4.384.10007 for All Supported Products

    Some good news: I removed the gigabit switch between router and node and this makes a huge difference. Then it also accepted ethernet priority and does not try to node wireless. Another tip for the people who still dont know : add a node allways after a full reset and with the node only...
  5. G

    [Official Release] AiMesh Firmware v3.0.0.4.384.10007 for All Supported Products

    I have 2 ac68u. One router aimesh, one node through wired connection. Besides the similar unstable behavior and the node disappearing as many people have(edit: stabilized by removing in between switch) i had following behaviour which i did not understand: I turned the node off to reboot using...
See more
Back
Top