Recent content by gz2021

Yeah no thanks, ive already been burned by that too

I dont use the app, never liked it Thats the thing, I dont sit on this forum. I only check it when someone responds to me.

Thanks for the heads up! I wish there was a way to get email notifications when updates are released

I use the devices as access points only, not a router. So far so good (been in a class streaming all day with no drops)

Went right back to that firmware

I just downgraded, I will probably do a reset it off hours

I ran into something like this with the latest firmware. I would drop a bunch of packets from my laptop and then it would randomly connect back up (my laptop looked like it was connected to wireless). Rolled back to 42095 also

I tried this firmware again because everyone was raving about it, was having an issue where my laptop looked like it was connected to the wireless but I couldnt even ping the local gateway. (wired worked fine) Downgraded back to 42095

pfsense(does all the layer 3 routing on my network)----unifi switch----(port assigned to vlan 100)-----asus made node in AP mode -----wireless-----2nd Asus in AP node No issues so far

Im using it AP mode with one wireless nodes with pfsense and have no issues so far. I am sticking with the 42095 firmware for my environment/my devices You lose the guest network mode in AP mode if you are looking to dump IOT devices to their own network. If all your devices are gonna be on...

I downgraded back to 42095 yesterday

Could you clarify this statement? I updated my main access point and all the other nodes look to get the update when I clicked the nodes under ai mesh Last night the SO ipad didnt seem to want to load up netflix. Moved it over to another wireless network and it seemed to load. So might be...

Did a factory reset and the main wired node is showing red still, but so far everything is operational. Will watch it for a day or so to decide if I want to revert back or not Is there a way to remotely factory reset the wireless nodes? I know there is a button on the back, I was just...

XT8 3 pack in Access Point(AP) mode / AiMesh Router in AP mode, upgraded this afternoon. Main wired access point is showing a red light Both wireless nodes show white lights. Internet is working and clients are talking so other than the red light things seem to be working fine. I noticed...

Went ahead and factory reset and setup everything in access point and can confirm I was running into an issue where the backhaul radio took the same SSID as my client SSID. I now have a SSID dedicated to the backhaul radio, so we will see if those IOT devices start working again. This time...