Menu
What's new
By:
Filters Better Search

Recent content by hakanson

  • SNBForums Code of Conduct

    SNBForums is a community for everyone, no matter what their level of experience.

    Please be tolerant and patient of others, especially newcomers. We are all here to share and learn!

    The rules are simple: Be patient, be nice, be helpful or be gone!

  1. H

    RT-AC68P WAN slow after merlin 380.69 to 384.19 upgrade

    I can confirm the same behavior here. On the older firmware, bandwidth limiter works fine for the restricted machines while the non-limited machines can get the full 900Mbps, even after multiple power-cycles and reboots of the router. I'd say that the ASUS engineers quoted in the above article...
  2. H

    RT-AC68P WAN slow after merlin 380.69 to 384.19 upgrade

    The use case for bandwidth limiting here is that we have a number of devices which are capable of soaking up all available bandwidth (download). In particular, the Apple TV 4K, at the start of a new video stream, would saturate our link and cause game-play to suffer from latency/lag problems...
  3. H

    RT-AC68P WAN slow after merlin 380.69 to 384.19 upgrade

    Yes, in fact the above was about 5 hours after a reboot. Note, however, this was with a QoS Bandwidth Limiter enabled, since I had found that disabling the QoS did not improve the speed. Update: Disabling QoS, and then rebooting, does get Hardware Acceleration enabled: After doing the...
  4. H

    RT-AC68P WAN slow after merlin 380.69 to 384.19 upgrade

    Oh, interesting. It leaves you hanging, saying just: That's different than before.
  5. H

    RT-AC68P WAN slow after merlin 380.69 to 384.19 upgrade

    Greetings, I upgraded from asuswrt-merlin 380.69_0 to 384.19_0 earlier today. Yes, I did reset-to-defaults after the upgrade (manually re-entered settings). Prior to the upgrade, I was getting wired download & upload speeds of 900mbits/sec. After the upgrade, the best I can get is...
See more
Top