Recent content by Hunterx

Thanks for the reply. I have at least 14 WiFi devices, more if you count guests, and directly wired devices. PC's, laptops, phones, tablets, printers, ring, etc. My home is close to 3000 square ft, and 2 floors. The main AP has great line of site access to most of the house. More than 3/4 has...

PROBLEM: 1) My current setup works, but cannot be upgraded to latest firmware and remain stable (see below). 2) wifi is weaker in the bedrooms on the opposite end of the house, and that may be more significant soon with needs for more PCs in those poor signal rooms (-70+ dbm, and -80+ if...

I started experiencing this same issue after upgrading to 384.6 from 384.3, except that I may have some other issues as well. my setup: router = pfsense 2.4.4 p1 AP = RT-AC3200 (Rev 0 v71) 384.6 (worked fine on 384.3) - Tri band / 2.4(printer, ring, and old PCs), 5Ghz-1 (hidden+isolated, for me...

I have been tracking this disconnect issue since March and it's still not fixed. I had hope that the DNS and routing fixes in 384.8 would fix this, but it has not. I have even tried the LTS E firmware, but was told that the issue may be with the AiMesh Asus wireless drivers, and that firmware...

try 192.168.29.1.

That may be correct, but I did hold for about 10 full seconds. The lights did not flash or reset until after I released the button. It seemed to reboot after that so I thought I did it correctly. It was reset enough to make me go through the manual setup again. I have set the AP to fixed 36...

My AP (RT-AC3200) currently has that 5ghz connection (5GHZ-1) on Auto channel (currently 36), and operating on 80mhz. I may have made a mistake when flashing. I used the recovery mode GUI to flash the firmware (hold reset button 10 seconds after power on). After successful flash, I reset...

The LTS fork disconnected twice in a different way. I just flashed back to 380.70. This is extremely frustrating. I may abandon ASUS as a result. I have lost all confidence in the product line.

I have just flashed the Merlin LTS fork onto the bridge (RT-AC68U_374.43_33E7j9527), and so far it is performing well. I am hoping Merlin will also maintain a LTS on 380.X. I need stability and security updates over new features. The forked version appears to be the only option out there that...

just for background info, I had this similar issue earlier this year with all of the early 384.x builds. I have been unable to get the Bridge mode stable past 380.X. What is happening so far on 384.6 is being disconnected from the internet while being wired into the bridge. This happens...

I had some pretty major problems with the RT-AC68U bridge mode on 384.3. Has anyone tried bridge mode yet on 384.4 beta 3?

I wish GCM support was more wide spread. The reason I want to switch to GCM is because there is a flaw in the way OpenVPN for iOS handles CBC. https://nvd.nist.gov/vuln/detail/CVE-2018-0488

Does GCM work on iOS OpenVPN Connect 1.2.9? I can’t seem to get either 128 or 256 to work.

I had the same issue. Factory reset, reboot, then try again.

I found this recently. It's really good info: https://www.snbforums.com/threads/faq-nvram-and-factory-default-reset.22822/