Recent content by jgarrigan

Thank you for the suggestions. Regarding "removing minidlna.postconf", I am pondering a method that won't stress the USB thumb drive. The thumb drive contains the entware installation.

Thank you for the suggestions. I changed the title of the post. It should be noted that for testing, I did enable iTunes. The iTunes player in my Windows-based computer could not see it. Both devices are part of the same LAN. I reverted the iTunes setting to its previously disabled state...

UPnP media server [RT-AC3100] not functioning after firmware upgrade to version 386.14 It functioned before the upgrade. I only used the UPnP media server [DLNA]. I confirmed that the data is accessible. I do not see active daemon processes. I did see the processes for a few seconds after I...

I will do so.

It functioned before the upgrade. I only used the UPnP media server [DLNA]. I confirmed that the data is accessible. I do not see active daemon processes. I did see the processes for a few seconds after I set "Rebuild entire database at start" to "Yes". I could also see the "rm" command for...

Update: I restarted my equipment. I have not encountered any problems. I am actively looking for new opportunities because the contract for the last job ended on 21st July 2023. https://www.garrigan.nyc

I also encountered the same problem as saccleo. I resolved the issue by reverting to an older version of libuv.so.1.0.0. I had an older version on a USB stick. I am actively looking for new opportunities because the contract for the last job ended on 21st July 2023. https://www.garrigan.nyc...

Feedback -- RT-AC87U, /tmp/nat_rules_vlan2_vlan2, Goal: Convert to a pure router for an IT Lab | SmallNetBuilder Forums (snbforums.com) I resolved my problem. I set LAN - Switch Control - "NAT Acceleration" to "Disabled".

I resolved my problem. I set LAN - Switch Control - "NAT Acceleration" to "Disabled".

I resolved my problem. I set LAN - Switch Control - "NAT Acceleration" to "Disabled".

Firmware version 384.13_10, the last version available for this model. Thank you for the suggestions. I allocated too much time to this challenge. I created a Vyos router in VMware workstation for my simulation.

Only the IPv4 traffic is affected. This device does not have a NAT table within ip6tables. Have you executed iptables -t nat -S ? It is also possible our respective devices function a bit differently.

The routes exist. Interestingly enough even after I remove the NAT rule I am able to confirm via traceroute that ICMP traffic flows back and forth between two test machines, one on each network. However other traffic does not flow. If this was a mission critical issue then I would have...

Hi Dave, After I disabled NAT via the web interface the traffic stops flowing. From within the web interface both the IPv4 firewall and the IPv6 firewall are disabled.

Hi, I am attempting to convert a RT-AC87U to a pure router with non-blocking/non-altering iptables/ip6tables rules for an internal IT lab. I resolved my problem. I set LAN - Switch Control - "NAT Acceleration" to "Disabled". After I disabled NAT via the web interface the traffic stops...