Recent content by Jings

I've seen something similar on my RT-AC86U after upgrading to 386.9 as well. Devices failing to authenticate, with "wrong password" error message on the device., and/or not re-authenticating when they come into range. Sometimes it helps to just manually try ty reauthenticate, but for devices...

I'm using some "Lyra Mini's" as AIMESH nodes, with AIMESH 2.0 beta FW They don't support Merlin, so I can't use the above, for the client configuration. But if you remove uiScribe temporary on the primary router, and use the default "System Log" interface, you can enter a Remote Syslog server...

A factory reset gave me a DHCP IP from my ISP on FW version 386.5.2! Restored the nvram setting with backup script, and the problem was back. Factory reset again, and restored block by block, with reboots in-between, until it failed at "IPTV Settings". Factory reset again, and did line-by-line...

Dirty upgrade from 386.3.2 on my RT-AC86U, and I'm unable to get a DHCP IP addresses from my ISP on any of the 386.5.x versions. Aka "Your ISP's DHCP does not function properly." Downgrading to 386.3.2 or 386.4 solves the problem, and everything starts working again. I've looked at the DEBUG...

I've concluded that I've got a different problem with my RT-AC86U, than what's talked about here, although I use many of the same settings, for example "Connect to DNS Server automatically"="No", "Network Monitoring"="DNS query", and are using VPN. Mine shows "Disconnected" as well, but that's...

Somewhat related problems with my AC86U on 386.5: The router could not get an DHCP address from my ISP, shows "Disconnected", and I can't get online with that version of the firmware. I'm using "DNS over TLS", and "Connect to DNS server automatically" to "No". Downgrading to 386.4 or 386.3.2...

One more thing... the usr/sbin/modem_at.sh command is extremly picky about formatting! Especially spaces is a problem. When writing bash scripts, I ended up replacing all the spaces with "No-Break Space" U+00A0 Alt-0160, as I wasn't able to get things to work with just escaping them. Ends up...

I've configured the router to send me SMS messages when the WAN changes from primary/secondary, and used a syslog-ng server to capture messages from my UPS, and SMS alert me of any power failures. I have not had any need to receive SMS messages, but I assume it might have some use cases. Some...

For anyone finding this post in the future (as I did), I was able to send SMS messages from the shell using the following commands /usr/sbin/modem_at.sh +CSCS=\"IRA\" /usr/sbin/modem_at.sh +CMGF=1 /usr/sbin/modem_at.sh +CMGS=\"+4712345678\"\\rTestMessage\^Z For Multiple lines / lines with...