Menu
What's new
By:
Filters Better Search

Recent content by jmshapir

  • SNBForums Code of Conduct

    SNBForums is a community for everyone, no matter what their level of experience.

    Please be tolerant and patient of others, especially newcomers. We are all here to share and learn!

    The rules are simple: Be patient, be nice, be helpful or be gone!

  1. J

    Second device not working on home MoCA network

    Thanks @krkaufman @degrub. Short story: I gave this a try and it worked! Longer story: I reset the ASUS back to factory and upgraded firmware. I turned off the WiFi radios just because. For now I haven't set the TPLink to Access Point mode because everything seems (?) to be ok as is. Will...
  2. J

    Second device not working on home MoCA network

    @krkaufman just to clarify what I should do in the RT-AC68U config, the user manual is here. In section 4.1.3 it offers modes AP only, WDS only, or Hybrid. Is one of these what you have in mind by "router" mode? (Alternatively in section 4.2.3 it allows me to "enable static routes." This seems...
  3. J

    Second device not working on home MoCA network

    OK thanks! I will give this a try and report back.
  4. J

    Second device not working on home MoCA network

    Thanks very much. Seems like we are getting to the bottom of this and I really appreciate the help running down the issue. I'd like to leave the TPLink Router where it is because its current location gives a good signal throughout the house. In terms of moving the modem, every time I've had...
  5. J

    Second device not working on home MoCA network

    My Actiontec adapters have three lights: Power (Solid green), Coax (blinking green), Ethernet (glowing green, can't tell for sure if it's blinking). I disconnected everything not in use. I powered down all devices on the network. I then powered up only the Second Device. It worked. I then...
  6. J

    Second device not working on home MoCA network

    It was a CISCO DPC3825.
  7. J

    Second device not working on home MoCA network

    Yes! Coax lights are blinking on all Actiontecs. Changing the configuration of amp/splitter ports doesn't seem to change the behavior. See below. Blue is the coax connected to the Actiontec that is connected to the modem. Red is the coax that runs to the device that is not working. The other...
  8. J

    Second device not working on home MoCA network

    Hi, I have Cox home internet service. I am using MoCA to run internet to a WiFi router and to a second device. I've put a wiring diagram below. The WiFi router is working fine but the second device is not getting internet. This is true regardless of which second device I use (PC, Roku...
See more
Top