Recent content by joec

I would like to report a possible BE58_Go issue that involves using mode profiles (Administration -> Multi-Function Button -> Home / Travel). I configured my router to have these two profiles: "Wireless router (Default)" and "Public WiFi (WISP)". To switch between modes, you need to unplug the...

The ability to update the "Trend Micro's Signature version" seems to work for all versions except the BE58_Go. I was able to update the signature on both my AX86U Pro and BE92U.

Dirty upgrade on by BE58_go from alpha 2 to beta1. The two options, "Enable local NTP server" and "Intercept NTP client requests" are available in both Router and WISP modes. I can not update the "Trend Micro's Signature version" in either mode. I see the following two messages during the...

AiProtection is enabled and in this router only "Router Security Assessment" and "Two-Way IPS" are supported. It is missing "Malicious Sites Blocking" and "Infected Device Prevention and Blocking". In the EOM version of the EB58_Go's firmware, the updating of Trend Micro Signature does work.

In an attempt to obtain more information, I loaded the prior version (3006.102.6) and configured the RT-BE58 Go in "Public WiFi Mode (WISP)" mode. Both versions (3006.102.6 & 3006.102.7-alpha2) have the same problems. And, I do not experience these problems in either of my other two routers...

The file /tmp/sig-upgrade.log does not exist on the BE58 Go. But, it does exist on the AX86U Pro & BE92U.

I too can update the Trend Micro: Signature version on my AX86U Pro and BE92U. But, not on my BE58 Go.

Just upgraded my RT-BE58 Go to alpha2 and performed a "Factory default Restore". The issue that I reported on Jan 23 in post #40 still exist. If the router is in "Public WiFi Mode (WISP)" mode, and you go to (Administration -> System): the options "Enable local NTP server" and "Intercept NTP...

Just installed 3006.102.7_alpha on my be58_go. If you configure it in Public WiFi Mode (WISP) mode. The options "Enable local NTP server" and "Intercept NTP client requests" are missing. These options are available it you configure this route in Wireless router mode.

After several quick tests, RMerlin's post #263 ("Ports are enumerated in the wrong order on the RT-BE92U:") has been fixed.

Still experiencing issues with internet access and the display of active ports. I installed beta 2 on my BE92U and performed a "hard reset" (WPS & power). The issues that I observed were described in messages 7 & 12. The following outlines the "Ethernet Ports" display issue. The table is the...

After reading Poul Bak's post, I decided to post the displayed ethernet ports. The router is configured to be "WAN Auto Detection". Maybe these two screen captures will be of some hope. The following is with the internet connection via the 10GB port. Note / Issue: My laptop is hard wired into...

I did both "resets" ("factory rest" via administration) and a "hard reset" (WPS & power) whenever I load new firmware on this router. Since it's a "test" router, its configuration is very simple. I configure it with what is necessary to test those items that need to be tested. I've experienced...

I just loaded 3006.102.5_beta1 on my BE92U router. I was using ASUS stock. I'm now experiencing issues connecting to the Internet. The 10GB port works. The connecting issue is with the 2.5GB WAN/LAN-1 port. I've tried the following settings for "Primary WAN". - WAN Auto Detection -- 2.5 GB...