Recent content by Joseph Gan

Yes, clients can roam between meshes, but their IP address will change and existing connections will drop, as the roaming is not seamless. However, since this is between two buildings, this roaming will not happen frequently and maintaining two separate meshes looks like a feasible setup for...

"Router" in your diagram must be an AiMesh router, for this to work. Two AiMesh nodes cannot peer with each other through the WAN port.

Do you use the Reboot Scheduler? I have my Asus routers all set to reboot daily at 4:00 am. It's under Administration: System: Basic Config. I have Smart Connect enabled, and haven't had any problems with that.

As some posters above have commented, these leaked beta firmwares seem to work far better than the old stable firmwares for the Lyra; that was my experience for Lyra Trio as well. I'm sure Asus has their reasons for not releasing these beta firmwares officially, but if you have any ability to...

This firmware seems to be working quite well so far. Instability issues seem to have been fixed.

Ah, sorry, mine is the Lyra Trio, on 9.0.0.4.386_41615; the firmware you listed is for the Lyra. If your source does have a later (unofficial) beta for Lyra Trio, I'd be happy to try it out.

Update didn't work: "Firmware upgrade unsuccessful. This may result from incorrect image or error transmission. Please check the version of firmware and try again."

I can confirm that this firmware is too buggy to be used. It's not started properly the last two auto-reboots, and connections have been unreliable. I am using this for AiMesh router and nodes, and have decided to also roll back to the previous firmware which was working fine.

If you uploaded it, where did you get the file from before this?

Can't seem to download. Where did you find this posted from?

https://www.snbforums.com/threads/lyra-map-ac2200-aimesh-2-0-beta.72267/post-687000 ...386.41615. I haven't seen any 386.46132 for the Lyra Trio.

I've been using this for about a year or so. Haven't had any problems, and even though it is an unofficial beta and not available through official channels, it has worked better for me than the very old stable release.

Where do you see that? I only see 3.0.0.4.386.41615 in the beta download page link listed above.

I've been using this since June, and it works far better than the stable firmware. I'm not sure what's holding up the official release, but if you're facing problems with the stable firmware, especially around AiMesh performance and reliability, I would highly recommend this unofficial release...

Parental Controls - Web and App Filters ==> doesn't seem to be working. The button can't be turned on and the managed clients can't be listed or added anymore.