What's new
By:

  • SNBForums Code of Conduct

    SNBForums is a community for everyone, no matter what their level of experience.

    Please be tolerant and patient of others, especially newcomers. We are all here to share and learn!

    The rules are simple: Be patient, be nice, be helpful or be gone!

Recent content by jvande

  1. jvande

    Double NAT and SAMBA

    sfx2000: The SAMBA server is running on Router B attached via USB. It is a 1TB USB3.0 drive attached to an ASUS RT N66U router with a share name of \\SERVER thiggins: There is an option for an "Enhanced Bridge Mode" as well, but I've only enabled the "Advanced DMZ". Both Router A and Router...
  2. jvande

    Double NAT and SAMBA

    thiggins: The DMZ is turned on Router A through a feature called "Advanced DMZ" in the router's settings. You set the MAC address of Router B and then Router B gets an external IP instead of an internal IP of 192.168.2.xx. Then Router B is basically connected as if there wasn't a router A at...
  3. jvande

    Double NAT and SAMBA

    I can't turn my router into an AP as then I would lose my ability to VPN (which my ISPs modem/router doesn't allow) and my DDNS wouldn't work. What router would you put the static routes on? Router A I'm assuming. How do you do this? Thanks. Router A's Static Route Page - I can't enter the...
  4. jvande

    Double NAT and SAMBA

    This, I’m sure, is not a unique problem, but I’ve tried a couple of different things that don’t seem to work properly. I’ve drawn a quick diagram to illustrate my current setup: Here is the problem. I’d like to access, via Samba (Windows share), Router B’s hard drive from Computer A...
  5. jvande

    Slow rsync

    This is good to know - now I just have to take the time to figure out (again) how to set up ssh keys again - or can we use the same key?
  6. jvande

    Slow rsync

    I too have very slow rsync transfer speeds. I was able to get my SSH keys working after a lot of reading. (Thanks for the link - that's the one I used too) Transfers start at 15MB/s and degrade quickly such that within 60 secs they have "stabilized" at about 250kb/s - much slower than my 20MB...
  7. jvande

    SSH Keys and rsync

    Ok, Kind of a newbie question here, but I've been looking for about 4 hours now trying to figure out how to do this: I have a USB HD hooked up on /mnt/BACKUP I'd like to remote SSH into a server and rsync files on the remote server to my USB HD. (a backup system). I can SSH into my...
  8. jvande

    Lan port Isolation via Command line - how to

    This may be a stupid newbie question, perhaps answered somewhere before, but I've looked and can't find the right information in all of the wrong places... On the WIFI page, when "Access Intranet" is disabled, these 2 ebtables rules come into being: -i wl0.1 -o ! eth0 -j DROP -i ! eth0 -o...
See more
Back
Top
✖