Recent content by kdkrone

Good thinking. I should have thought of it. Thanks, Ken K

Would someone be kind enough to post a screen shot of the Wireless->Professional default settings (either for 2.4GHz or 5GHz. I think they are the same)? I have changed a few settings without taking a screen shot before I started and I would like to get back to default without doing a reset and...

I would be grateful if someone could take a minute to tell me if I have returned the settings in Professional to "default" (I have entered a number of static leases and some port-forwarding and would prefer to not do a reset to default) (I could not find them in the manual) Are these the...

Right you are. RT-AC68U. Turns out that the signal strength is so good I have no need for access points. Thanks for pointing out the error, though Ken K

Glad to bring some mirth into your day. ;) When we moved in, the best that I could do was to use the existing CAT5e wire in the phone jacks in the walls. At least they ran to a small wiring cabinet in an upstairs centrally located closet... I prefer to stay married. :eek: How far off...

I have just set up an RT-AC68U (ASUS Firmware 3.0.0.4.376_1663) on my home network and would like to know how I can test it and tweak it to know if I am getting real world "expected" (or close to full) results. My provider is Charter and using their speed test, I have 31 Mbps download and...

I am going to install my new router soon and before I get myself in trouble, I thought I would ask in advance. Question 1. I have searched the manual, but I did not find anything about static lease assignments WRT whether static leases should be assigned within a defined DHCP range (I am...

I just purchased an RT-AC68U to replace slower routers (Linksys 150n, 350n, and 350n). I will have need for one, and possibly two, additional wireless connection points. The first is about 6 feet from the router, but my wife says no holes in walls or exposed CAT5 wire. I have the extra...

Great minds... (by luck on my part). The other day after I bricked my 300n and pulled my 150n into service, I had experimented with your process by putting in addresses with MAC addresses of 00:00:00:00:00:01, etc., and that seemed to work. By the way, other than using an ipcofig /release...

Thank you both for your replies. WRT your question, HTISMAQE, I presently have a Linksys 150n runnign DD-WRT firmware. It had been setup with a router of 192.168.0.100 and a DHCP range of 100-150. Almost all of my equipment has static leases, including computers (laptops and desktops), iPads...

I am re-doing my home network and have been searching out basic issues that I am having difficulty clarifying on the internet, so if anyone can answer or point me to where I can go on the internet, that would be appreciated. First, WRT IP addresses. Am I correct that a private 192.168...