Menu
What's new
By:
Filters Better Search

Recent content by kennymc.c

  • SNBForums Code of Conduct

    SNBForums is a community for everyone, no matter what their level of experience.

    Please be tolerant and patient of others, especially newcomers. We are all here to share and learn!

    The rules are simple: Be patient, be nice, be helpful or be gone!

  1. K

    AC86U reset and firmware restoration fails

    Do you mean another or a different hardware failure or something that could be fixed without replacing a chip on the board?
  2. K

    AC86U reset and firmware restoration fails

    With the new power supply, the WAN and Wifi LEDs still remain off. Then it is probably the mentioned faulty voltage regulation chip.
  3. K

    AC86U reset and firmware restoration fails

    Yes, it is an AC86U. I will first try again with a new power supply, which should arrive today, but I have already read about these cases. Thought so far that the router then no longer shows any sign of life or only the LAN 4 LED is on. Had already ordered an AX86U yesterday as a replacement...
  4. K

    AC86U reset and firmware restoration fails

    My AC86U doesn't seem to work properly since yesterday. The WiFi and WAN LEDs do not light up and I no longer get an IP via DHPC. After a reboot via the power button on the device only one of the LAN LEDs had blinked in a very high frequency. I suspected the power supply, unplugged it and...
  5. K

    blog_key corruption when adding / deleting flowfor net_p

    After almost 7 months in contact with Asus support, the problem has now probably been solved. I have received 8 test firmware versions from Asus in this time and the last one seems to finally cause no more crashes with Wifi Calling on the iPhone. With the test version the log level is set a bit...
  6. K

    blog_key corruption when adding / deleting flowfor net_p

    I have probably found the reason: Wi-Fi calls. I reset the network settings of the iPhone last week. After that, no more messages or reboots occurred. I had then noticed the next day that wifi calls were disabled. But when I activated them, the messages reappeared. I then reset the network...
  7. K

    blog_key corruption when adding / deleting flowfor net_p

    It is definitely my iPhone that is causing the errors. I have tested disabling Wi-Fi for several hours and the errors disappeared. In between I restarted the router but as soon as I re-enabled Wi-Fi, the messages reappeared. What I noticed though is that when I connect the iPhone to a guest WiFi...
  8. K

    blog_key corruption when adding / deleting flowfor net_p

    Yesterday the error messages stopped when I went to work but when I came back they did not repapered until about 3,5 hours later. So I assume my iPhone is not the main reason. These are the log messages after the last reboot from this morning: https://pastebin.com/fem9FhxM
  9. K

    blog_key corruption when adding / deleting flowfor net_p

    I can confirm that. As soon as I am no longer at home, the messages no longer occur. As soon as I am back, they are there again. The only device I have taken with me is an iPhone. A MacBook was still at home in standby but that doesn't seem to have any effect. Unfortunately, reboots are now...
  10. K

    blog_key corruption when adding / deleting flowfor net_p

    I have also noticed these strange log entries recently. They occur about every 3-5 minutes. I was wondering 4 days ago because my AC86U seems to have rebooted at some point. Could have to do with the messages as mentioned above. Otherwise, however, I have not noticed any strange behavior. I run...
  11. K

    ASUS firmware DHCP "Continuous Mode" potential fix for "ISP's DHCP did not function properly"

    The error has occurred more frequently in the last few months with an AC86U. At the beginning, when it did not occur very often, I just re-plugged the LAN cable of the WAN port. This worked fine, because it occurred maybe 1 maxmimal 2 times a month. Interestingly MS Teams meetings were not...
  12. K

    connmon connmon - Internet connection monitoring

    Thanks, that solved it.
  13. K

    connmon connmon - Internet connection monitoring

    After the update to 2.8.0 there still seem to be problems with the renaming of Paket_Loss column to LineQuality. The table for Quality only shows "no data to display". Also in the other tables the last tests results do not appear. The download of the data results in a 0 byte CSV file. If you run...
  14. K

    spdMerlin spdMerlin - Automated speedtests with graphs

    I also had this message but not after a reinstall. It basically means there is a lockfile in a temp folder that prevents spdmerlin from running because this file should only exists when the script is performing a speedtest. Which firmware are you using? For me a hard reboot solved this. A reboot...
  15. K

    [Release] Asuswrt-Merlin 384.18 and 384.13_10 is now available

    I think I found the reason for my problems with OpenVPN. Although I clicked apply after creating the new OpenVPN users and then rebooted, the router does not seem to have added the users to / etc / passwd and according to the system log it also did not reboot at all. The file even contained the...
See more
Top