Menu
What's new
By:
Filters Better Search

Recent content by kensey

  • SNBForums Code of Conduct

    SNBForums is a community for everyone, no matter what their level of experience.

    Please be tolerant and patient of others, especially newcomers. We are all here to share and learn!

    The rules are simple: Be patient, be nice, be helpful or be gone!

  1. K

    Adding config for a local DNS causes slow connections

    There *is* a loop, but I'm not sure why it's happening. In the Pi's dnsmasq logs, I see nothing after I start dnsmasq till a query comes in from the router asking it to look up metadata.google.internal.my.internal.domain. It forwards that query back to the router, which then asks the Pi to...
  2. K

    Adding config for a local DNS causes slow connections

    It’s just a regular Pi running Raspbian that I set up dnsmasq on. I’ll check the config on it later today and see if it might be looping —it *shouldn’t* be, but then again I set it up early one recent AM and well, I probably wasn’t 100% awake when I finished...
  3. K

    Adding config for a local DNS causes slow connections

    I recently set up a Raspberry Pi as the internal DNS for my lab that my RT-AX3000 is the gateway for. The intent here was to have queries for internal lab hostnames recursively forwarded to this DNS but use my ISP's DNS for regular outbound queries. So I turned on the "Enable JFFS custom...
  4. K

    Site-to-site OpenVPN without both sides in the same-numbered IP subnet?

    Great stuff! I don't want to mess with it remotely but as soon as I'm back in the office on Tuesday I'll be checking out what works. Thanks folks!
  5. K

    Site-to-site OpenVPN without both sides in the same-numbered IP subnet?

    I'm trying to set up site-to-site VPN between my office and home, but I have a couple of issues that mean I can't set it up in the config the tutorial article for that uses: Office network is not numbered the same as home (192.168.33.0/24 at the office, 192.168.1.0/24 at home). I can't...
  6. K

    Router sometimes stops WAN traffic, allowing clients to associate with 380.61-0 on N66U

    A couple of weeks ago I saw that there was a new stable build of Merlin out, so I downloaded it and applied it to the router. Everything appeared to go OK, but since then, every few days the router will stop passing traffic to the WAN, and will not allow clients to associate to either the 2.4...
See more
Top