Recent content by laser

RMerlin I have a 2 AC68P - Setup as an AP using 378.52. I am unable to get the time set on one of the routers and the log is full of Start NTP Update messages (Approx every 30 seconds) I have reset it to factory defaults and set it up manually. The routers are configure identically so it is...

doesn't ASUS use 192.168.0.1 by default?

I personally will never purchase anything with the linksys name after my experience with the EA4200. Their support sux! I am sticking with ASUS and Merlin, its a sure bet they will keep updaing/fixing the AC68 long after Linksys moves on from the EA6900 Steve

There is a host of FAQs for configuring the FIOS router and your own router at DSL reports. I have mine set up like this: PRILANtoWAN.jpg It works perfectly the TV still gets the Guide info and Video on Demand, and my WIFI is N speeds. Here is a link to the FAQ that keeps your guide...

Merlin You are correct. I reloaded the settings for my network and saved them. And the time started working. Thank you for the assistance. Steve

Merlin I tried the command and recieved an unknown host error. I also have tried several different time servers with the same results. ntpclient -s -h time.nrc.ca setup_receive:: bind... time.nrc.ca: Unknown host The is the message in the sys log if I try setting the time from the...

Installed Beta 1, it is running very well. Did a restore to defaults prior to flashing and the 2.4 and 5 channel strength is great. Only thing I see is I am unable to set the time. I am using it in AP mode and date/time is stuck on Jan 1. It normally will set if I click apply on the system...

Been running the beta in AP mode for 2 days. So far it has been rock solid, my log is empty! Thanks Merlin

+1 on the stability going on 15 days since my unit has been rebooted. The only thing in my logs are these messages. But I am not sure what is causing them. I am using it in AP mode:

I use the +/- button and when I select apply a message pops up telling me it can not be blank. Edit** I looked at it again today and found the "use specific IP" radio button checked -unchecked that and I was able to delete the IP. Thanks for the help guys. Steve

Makes sense, is it a bug that once you enter an IP that it can not be removed. you can change it but never completely remove it. Steve

Merlin On the admin system page, what is the specified IP selection for? I am running my router in AP mode and was playing around with this selection trying to see what it did. I selected an IP from the list and entered it. Once this is applied, the router was unreachable from any PC except...

I also had this issue, once you select "apply" on the admin system page it will display the time but if it reboots then I have to go back and re apply the settings to have it fetch the time. Steve