Recent content by maghuro

Correct ☺️ Thank you for your answer!

Thanks for your work! One thing I noticed, if I choose a non existent menu option (let's say 22), the script exits 😅

Perfect! Didn't know that amtm had a "Clean uptime" command 😲 Great job!

Installed RTRHTR v1.5 on an RT-AX class unit for testing. Script executed cleanly, no syntax errors. CPU immediately locked at 100%, which I assume means initialization was successful. However, I believe I may have found a minor logic issue in the thermal control loop. During execution, this...

Ahahah Don't worry. I didn't save any logs unfortunately. And this was the first and only time it happened. Maybe there was some lock file between power failures, the script didn't save dates correctly, or the NTP didn't update properly when booting and was stuck with an older time. Many...

A ~40 seconds power failure gave me this 🤣

Well, right now I'm manually adding iptables -t nat -A "my_chain" -i "wgc4" -p tcp --dport "11111" -j DNAT --to-destination "10.0.0.10:11111" Where 10.0.0.10 is my client lan IP (not wireguard local ip), and I think is correctly working. Why do we need VPN local ip? Currently using AirVPN.

Dear friend, thanks for your work. Within the wireguard port forwarding, what's the WG_CLIENT_IP='10.0.0.2' variable? I think I'm failing to understand. Also, after running, does this append to firewall-start and so on scripts? Or I have to manually put this to run on those used scripts...

Guess what? 🥹

Thank you for your alert, and no, I haven't got the reason behind that... I checked and whenever a cron runs different from minute 00, upload is OK. Whenever it runs at minute 00 it caps the upload speed. There are many crons running at 00 minute, of course. So maybe the suggestion I have is...

I just set the Cron to run every 5 minutes (for the sake of debugging), and you know what? Correctly getting my upload speed. 🫣 Maybe the cron job I set to run every 6 hours just happens to coincide with peak usage times on the ISP’s side? Hard to tell… either way, thanks again for the help...

Thank you for your prompt help! 1 - no. Exactly the same. (I did notice however that controld binary is always using 55% of RAM 😯) 2 - Even with an even lower priority, manually triggering it (both via generate or interactive menus), the results are the same, with 400mbps upload. I'll wait for...

I'll try with preferred server, and I'll report later. I double checked, just to be sure, not via VPN. It's using wan

There's something odd happening with my spdmerlin, and I can't figure out what 😅 Whenever I run a manual Speedtest (auto server), it uses correctly my upload speed (around 400mbps). Whenever it runs unattended via Cronjob, it's capped around 150mbps. Every single time . Auto server also...

Understood. And what about the possibility of getting a column with the interface in the log/port forwarding section?