Recent content by maidmeow4

It works! Thank you!

Hi, I had a clean install of merlin 384.19 on my RT-AC66U_B1, this script did worked first time, but after I log back in amtm still gives error messages when installing a module or doing an update. Did follow your instructions, the script did say "all done here" after first run. Running it again...

dirty flash from 386.3_2, currently I have two problems: 1. WebUI often says Internet disconnected, but after 1 or 2 minutes it disappears and shows connected again. 2. Random lost of connection inside online games, this only happen one hour or more after the router booted up. For problem 1, I...

syslog file pulled from the router, log level = debug. https://drive.google.com/file/d/1cTSGJsW_1oUCLIM0GYNYX-gt8miW2pAi/view?usp=sharing

Router: RT-AC66U B1 with merlin 386.3_2 I have some custom iptables rules to block some ip addresses, on merlin 384 these rules works fine, but on merlin 386, once the rules were triggered, the router crashed and reboots. No matter how I add these iptables rules (firewall-start or directly from...

The router started reboot randomly again, I was able to save the syslog from router webui, please take a look. I assume my custom firewall-start script casuing this, the script is attached below. This script file is the only one I created, all other scripts were created by amtm. Edit: Unable to...

Looks like one or more of my custom script and config file on the jffs partition causing this issue, now I'm restoring them one by one trying to find which file has problem.

Thanks for the reply, I just formatted jffs partition, will see if reboot still persists. Btw, those scripts works fine with 384.19 firmware, will they cause issues in 386 firmwares? I thought log is cleared after reboot so I setup a syslog server, will check it next time.

Yes I do turned on Trend Micro features, I think that will make my router and home network safer ...? Anyway thanks for the suggestion, will try this!

@RMerlin please help, thank you!

The router just rebooted once again, this time looks like it gives a very detailed syslog? Not everytime it outputs this much log, sometime it just reboots without any log. Link to the log file is HERE. (not the full log, I cut the log file from the first kernel alert message.)

The router reboots right after these logs captured. Can anyone have a look please? 192.168.5.1 Aug 11 23:09:48 RT-AC66U_B1-0C10-95E2992-C kern alert kernel Unable to handle kernel NULL pointer dereference at virtual address 00000000 192.168.5.1 Aug 11 23:09:48...

RT-AC66U B1, HW version B2, using merlin 386.3_2 firmware. Symptom: random reboot, sometime around 20 ~ 40 minutes, sometime right after the router completes boot (I assume the power led slow blink few times means power up complete). Previous version 386 firmwares also has this problem, however...

Hi, I have a RT-AC66U_B1 and recently flashed 386.1_0 and 386.2_2, both of them randomly reboots. EDIT: my flashing procedure: 1. power off and hold wps button and power on, 2. wait for power led blinks then release wps button, router reboots, 3. after router reboots power off, 4. hold...

Hi, I'm using v386 on my AC66U_B1 and it always reboots after couple of minutes/hours, no matter upgrade from v384 or a fresh install. But v384 don't have this problem, this really annoys me. EDIT: tried 386.1_0 and 386.2_2, upgrade from 384 or fresh install, both randomly reboots.