Recent content by marka2k

Update: Issue resolved I had to manually use the switch '--float' under custom commands. The GUI switch did not work. Discovered this after I found and reviewed the logs. Thank you R. Gerrits for the responses and the ideas.

Correct using the R9000 Router, i will do troubleshooting as you suggested with DNS thank you for the ideas.

Apologizes I was not clear, Everything works as expected when I am connected to Cellular or an outside Network, when I am in house on the Home Network I lose Internet Access unless I disconnect manually from the OpenVPN Client (I keep forgetting), Ideally the OpenVPN Client I could Whitelist my...

Update went smoothly, configured the VPN and tested everything went well except for OpenVPN for Android, normally I would think I can whitelist my SSID so VPN is not activated but the developer choose not to do so. If OpenVPN is running all Internet traffic is blocked while inside the Home...

@jlaine Same thing happened to me but on previous version I had to flash Netgear Latest Firmware, factory reset and then load Voxel Firmware, resetup and everything is well YMMV my experience from another thread...

@Voxel I updated to 39.1HF lost my settings however this time I was able to load the backup I created, readd Kamoj and recreated my OpenVPN Configuration all is well. Mark

@Voxel I have not tried 39.1HF I checked the other day and it was not up yet or I missed it. I will try later today when I have time. @Starrbuck Glad you got yours working as well, not sure that will fix everyone that is having the same issue or not or just a couple of us?

Update: YMMV - My router ran fine since my last post then unexpectedly rebooted itself and reset all settings back to default. I setup basic settings and downloaded Netgear Firmware, I tried twice to do a reset using the reset button on the back it, it would do a partial reset but not a total...

I got adventurous and tried to install Kamoj addon, I am back where settings are not saved. :(

I logged into the admin console and rebooted and the X10 retained settings, so as a test I powered down the router and restarted and it retained settings. I am at a loss on why it appears to be intermittent hopefully it will not occur again. Thank you all for replying and it is nice to know I am...

Starrbuck Thank you for the reply, not something I want to hear (obviously), this is the first time it has done it to me. What is weird is that when I tried to restore from the backup it stated completed and rebooted to activate settings but then came backup like a new router. I plan on...

I love Voxel's Firmware and my hat if off to you! However I am having some issues with this build. When I upgraded it erased all my settings when I tried to restore my settings from backup it would not, so I re-added my settings all was well until I rebooted my X10 at which time it reverted...

Voxel really appreciate your continuous support and updates! Please keep it up

I was using version 1.0.3 due to issues with WiFi 2.4 going up and down at the time, figured out running at 800 mode on the 2.4 band was the issue and changed setting to 347 after I confirmed that was resolved I updated to 1.0.4 all good now. I will bookmark the firmware thread so I can keep...

Update: Went to actual Voxel site and noticed under the R9000 a newer package I downloaded and installed successfully.