Recent content by mehravishay

Hi What is your router model? Asus GT-AXE11000 and an Asus RT-AC86U used as a mesh AP. The PC is connect to the mesh AP via a network switch What firmware version are running on the router? Merlin 3004.388.8_4 on the AXE11000 and 3004.386.14_2 on the AC86U What is the VPN service the VPN client...

Hello I am getting the following errors filling my system log to a point where the internet stops working and I need to either reboot the router or turn my VPN client on/off Feb 21 07:53:02 miniupnpd[3036]: Failed to remove PCP mapping to XX.X.X.145:47984 TCP Feb 21 07:53:02 miniupnpd[3036]...

I was able to resolve this by changing my upstream DNS on the PiHole to my WireGuard providers DNS and then tunnelling my PiHole on my router through my WireGuard client

My issue is my Wireguard IP and DNS are different and therefore streaming services always give me an error stating behind a VPN.

This is what I have done. My PiHole is using Quad 9 as upstream DNS so I have added that in the VPN director and my PiHole is also pointed towards the Wireguard server. However this is what I see in after tunnelling

I tried PiHoles source IP via the same WG server but now its giving me a DNS in Switzerland and Italy. For the Quad9 destination IP approach, should this be in Remote IP section?

Hello I have a Wireguard Client running without a DNS (Optional) and my LAN DNS is pointing towards my PiHole. However I am using a Quad9 DNS as my upstream on my PiHole which is causing a DNS Leak (technically not a leak because it isn't my ISP's DNS). I am having the same issue when I stream...

Restarting the connection was it! I left it connected and removed the DNS and clicked apply. Once I disconnected, removed and reconnected it worked. Thanks a lot for your help

If I remove the wgc1 DNS the results are the same.

I did that, the DNS on the config is my Pihole. Before the addition of the above lines it was working fine.

This worked like a charm, thank you so much! The only issue now is the traffic is not passing via Pihole, do you know what could be the reason?

Hi I have a GT-AXE11000 (Merlin) running a WireGuard server. I have a separate WireGuard client running on the same router and via DNS Director, I have 4 devices that are routed via the client locally. I also have a Pihole running and I am able to filter out my lan as well as server traffic via...